Electronics Forum | Tue May 01 16:36:12 EDT 2007 | ratsalad
I have been working with GSMs since 1999. Mostly, I've been programming them but for the past 2 1/2 years or so I've also gotten to know them mechanically. I think they are great machines. If you are looking at Flex head GSMs (4-spindle) they won'
Electronics Forum | Wed May 02 12:22:30 EDT 2007 | SWAG
Make sure you get a good upward looking camera combo. 4.0 on rear and 2.6 for PTF (platform tray feeder) parts is my favorite. Easy to wrench on, calibrate (if you have a cal. kit), and easy to program. Single beam will run at 2000+ cph and dual b
Electronics Forum | Wed May 09 12:14:08 EDT 2007 | mmjm_1099
I am wondering if anyone has tried to run a crystal report out of Fuji Flexa? What I would like to do is run the report that make a default feeder list for that certian day to minimize feeder setup times. So please leave me some feedback if you have
Electronics Forum | Fri May 11 07:38:14 EDT 2007 | tombr
It is possible to vary the length of lead during auto insert. However, it requires software and mechanical adjustments. Universal equipment allows small changes via software program for lead length. To change angle of clinch involves a mechanical a
Electronics Forum | Tue Jun 05 10:01:47 EDT 2007 | bartlozie
the temperature difference between solder and room temperature, So if you let the solder cool down, you need less energy then holding it on temperature + heating a bit up. 2. If you let the solder get to solid, you don't have oxidation. 3. If you l
Electronics Forum | Sat May 19 02:42:03 EDT 2007 | vinitverma
Hi Bart, I suggest you have a look at Assembleon's OPAL XII. They have a special offer at this moment. You can select the machine with 4 heads (standard) and later if higher speed is needed, you can upgrade it to 8 heads. the machine is capable of h
Electronics Forum | Sun May 20 23:15:34 EDT 2007 | dsd
George, The Radiator is only used on the older Nitrogen ready type Heller Ovens to attract the flux toward the Flux Filtration system. There should be two blowers in the Cooling zone where the radiator is to be fitted and there should be 4" ducting
Electronics Forum | Mon May 21 09:06:33 EDT 2007 | davef
Pat: Very descriptive SUBJECT choice. Surface tension: * Soldering and Surface Tension; Champion, JA; Physics Education, V 16, No 2, 1981, pp 98-100(3) Institute of Physics [We have not looked at this, so we cannot comment, but it seems like an appr
Electronics Forum | Thu May 24 22:46:10 EDT 2007 | colormaker
The waste water is filtered then sent to city sewer. When we first started we had inspections and then they said our volume was so low and did not require continued testing. We wash 20-40 boards a month. Small 3x4 inch boards. If we hand rinse the b
Electronics Forum | Tue May 29 15:10:30 EDT 2007 | realchunks
Hi Jerry, Sounds like the white stuff is flux. I doubt if 4 pcb mfgers could be undercuring all at once. Good point though. Since you changed washers and now have the problem - it's your new washer. Can you bring back the old one to make sure?