Electronics Forum | Wed Nov 06 05:13:01 EST 2002 | Dreamsniper
Crystalline flux if it is really clear should not be a problem. We were using Amtech paste before and we have the same results. Sometimes we mistakenly see it as a dry joint because of the reflections from the lighting of our Metcal inspection system
Electronics Forum | Wed Oct 30 09:43:01 EST 2002 | gregp
Larger tighter spaced balls will present a problem in sealing the vacuum cup. There will be more leakage in this case. It really depends upon the application. The BGA you mention should not be a major concern. The bigger problems are with bigger
Electronics Forum | Wed Oct 30 11:34:12 EST 2002 | Jeff Park
I purchased a used 1993 JOT stacker and when we recieved it the battery in the Omron Controller was dead so the program is lost. I have tried to get a copy of this program directly from JOT but they can not locate a copy of it as they say they have c
Electronics Forum | Thu Oct 31 10:25:00 EST 2002 | gregp
Contact Systems has a second (third, fourth, etc) owner support policy. There is a fee which varies for the various products. This fee includes a three day comrehensive training and entitles the user to unlimited phone support. The training is the
Electronics Forum | Thu Oct 31 08:02:12 EST 2002 | davidweir
we are looking at buying an screen printer and are curretly have an mpm up1500 and dek ela on the shortlist both silimar spec's except mpm has automatic tooling. being a cem having to change set up a number of time a week quick change over is a co
Electronics Forum | Wed Nov 06 18:27:18 EST 2002 | MikeF
At this time we will be hand spraying acrylic, probably using spray cans until we decide on a spray gun or an air brush, and get one ordered. Our volume is too low to even consider an automated system. Our current requirement is on an item designed
Electronics Forum | Wed Nov 20 12:56:58 EST 2002 | jasper
In my opinion MPM is superior as far as programming the 2D inspection. It's fast, simple and reliable. The DEK has options like Formflex. The MPM only offers adjustable vacuum box. It's difficult. 2nd hand prices are not similar. We offer used/refurb
Electronics Forum | Sat Nov 23 11:16:05 EST 2002 | mark
Transition Automation is offering a unique offline tooling system, which definetely improves the mpm machines compared to dek. Considering the big cost gap between used mpm and dek machines, if you buy mpm, and buy transitions instant fixture upgrad
Electronics Forum | Mon Dec 16 06:53:23 EST 2002 | lloyd
We simply don't allow any 'walkman' type systems to be used by anyone in our factory. It's simply from a health and safety point of view. Think of this scenario: everyone in a department wearing walkmans, a fellow worker in someway gets injured/falls
Electronics Forum | Thu Dec 12 00:36:11 EST 2002 | Frank
We had one of these years ago. We had trouble with it recognizing fiducials consistently, but other than that it ran good. This assumes that the left head, which is mechanical centering, is working good. And I believe that the minimum component
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
