Electronics Forum | Thu Oct 06 17:34:07 EDT 2011 | jrsmachine
Hello Tom. Thks for your response. I tryed all your suggestions. No luck. This is how it happened: Several weeks ago I allowed an inexperienced unsupervised operator to work on some program changes. When I checked back afew hours later I noticed
Electronics Forum | Fri Nov 04 22:12:57 EDT 2011 | machinehead
I know what you mean but have never found a tool > that would do this sufficiently. For higher > value parts you should keep them in a bag for the > next time you run a job that uses that part and > hand fit them. > > The nature of the feeders
Electronics Forum | Wed Nov 16 17:30:29 EST 2011 | olddog
Hi again Bobpan, One thing I noticed when I pulled the z-rod to inspect it was that it was "bearly" finger tight. When I replaced it, I snugged it a bit better (not overtightening). After resuming setting up additioanl placements (this board requires
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
Electronics Forum | Sun Jan 20 17:47:41 EST 2013 | ngineer
Bobpan, It's been a while, and I haven't really had a need for this (simple boards, with larger components), but now I'm back to a board that needs this. I only have options for HOLD, PASS or VISION under transport in the Sequence Programming.
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Mon Jul 16 15:47:52 EDT 2012 | davef
Here's what Desco says ... Humidity Indicator Card (HIC) A card on which a moisture-sensitive chemical is printed such that it will change color from blue to pink when the indicated relative humidity is exceeded. This is packed inside the moisture-se
Electronics Forum | Mon Aug 27 08:52:57 EDT 2012 | rgduval
Reese, We would agree about the value of an ICT system, in a general manufacturing environment. However, a couple of notes apply: 1. ICT isn't a catch-all, either, and should be used to verify the process, not validate it. Quality should be buil
Electronics Forum | Thu Aug 30 17:59:29 EDT 2012 | rway
It should also be noted that if you can control your humidity, you can reduce the chance of static build-up. Do you monitor the humidity in your facility? This alone, can be the greatest contributor to static build-up and ESD damage. But back to t