Electronics Forum | Mon Oct 05 16:54:40 EDT 2020 | kylehunter
LOL! I don't think it will change until we (CMs) actually start pushing back on these companies. Nutek charged me $100 for a 100 page PDF of a conveyor last year..
Electronics Forum | Mon Oct 05 16:58:23 EDT 2020 | lesfarnacer
thanks Guy for the replay, i am checking if there is other solution but the % are very low . and I will not accept paying 5k + 2k for activating an option that my machine already had.
Electronics Forum | Mon Oct 05 17:47:24 EDT 2020 | lesfarnacer
thanks for the idea. I checked the hardware limit and was missing only 2inch for this board. maybe with adding a metal piece 2inch long on camera stopper will work!
Electronics Forum | Mon Oct 05 18:02:07 EDT 2020 | dwl
I bought a used Nutek conveyor and needed to reverse the flow direction. I paid $100 for a 1 page PDF that just told me to reverse the wires on the motor.
Electronics Forum | Tue Oct 06 07:59:58 EDT 2020 | reckless
This is why I don't like DEK, I had better experiences with MPM. Its much better operating and using machines when you dont hate the manufacturer and feel like they are trying to rip you off every chance they get.
Electronics Forum | Fri Oct 02 17:06:02 EDT 2020 | dilogic
Is there somebody experienced in GSM Flexjet calibration procedures? I have some issues that I can't resolve and help is very appreciated... - Deni
Electronics Forum | Tue Oct 06 11:43:23 EDT 2020 | proceng1
Thank you Phil. You certainly had two documents that I did not have. I have downloaded them and I will go through to see if I can find what I need.
Electronics Forum | Tue Oct 06 08:19:38 EDT 2020 | leeg
How does everyone control what Squeegee Blades are used for each different PCB that they build through SMT particularly around the sizes?
Electronics Forum | Wed Oct 07 16:00:01 EDT 2020 | lpbro
Using MPM Momentums, I like choosing blades that allow about an inch of overhang on each side of the board. I feel it allows me to dial the squeegee pressure a bit better.
Electronics Forum | Tue Oct 06 15:14:54 EDT 2020 | rieko
Thank you Charlie! When the solder is cooled they should slide right out, correct?
.gif)
