Electronics Forum | Wed Sep 17 10:28:05 EDT 2014 | travishemen
We had a Dek 265 LT that had a similar issue. We suspected it was a bad cable going to the camera as the issue always seemed to show up in the same X Y location. Have you tried swapping fiducial 1 and 2 to see if it is always the first fiducial or
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Fri Sep 11 17:02:10 EDT 2015 | adeanda74
Simon, Normally that error is caused by a bad motor but also there is a possibility that a driver board or even the servo board are defective and last but not least check all your cables and connections. finally let me mention that you can also recei
Electronics Forum | Tue Dec 01 23:22:23 EST 2015 | ttheis
Swapped the EXM-13A with no change; going to try the EXM-14 card next. Do the monitors split from one VGA port via a cable splitter? I'm still working on getting manuals for this machine so I'm learning as I go so far, thanks for the help.
Electronics Forum | Wed Dec 26 07:55:27 EST 2018 | mermarinc
Last month, I had worked with California based PCB manufacturer and it was a great experience. They offer a complete solution for contract manufacturing services from PCB Fabrication, PCB Assembly, Cable harnessing and more for quick-turn and standar
Electronics Forum | Mon Feb 01 05:00:41 EST 2016 | oxygensmd
I haven't experiences with the asian suppliers, we order replacement parts from ASM, AdoptSMT or SaleCon. Both of them has replacement parts. Sometime this issue happens if the machine was not shipped properly. The heads need to fasten by cable tie
Electronics Forum | Thu Jun 02 04:20:58 EDT 2016 | jasltd
Thanks, I have managed to get a step further and now get the additional info on the error that it is node 1. All cables are connected, will double check the power but I believe it has power, I seem to be able to drive everything in diagnostics mode
Electronics Forum | Fri Oct 28 17:50:17 EDT 2016 | ttheis
Found a broken wire in the data line and I thought that was it for sure but was not. Checked continuity of the data cable and it is ok now but still no comm. The embedded controller status window shows "send failures" but no "reply failures." Winco
Electronics Forum | Thu Dec 14 21:56:25 EST 2017 | jmelson
I checked the brushes, there is lots of length left on them, and the springs and pigtails are in good shape, too. I have been checking various cables, and reseating connectors, but making a resistance measurement from the brush holders back to the s
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
