Electronics Forum | Fri Sep 15 10:46:14 EDT 2023 | tommy_magyar
Hi Dima, I use Speedprint printers mainly, and sometimes for some boards I encounter the same problem. Do you use pads or fiducials for alignment? Regards, Tamas
Electronics Forum | Wed Sep 20 10:45:11 EDT 2023 | kirill
Hello A scan board and scan full options has stopped working for me. Any idea how to make these functions work again ?
Electronics Forum | Fri Sep 22 12:11:31 EDT 2023 | wippsen
Hi there, if there is insufficient Volume you may optimize the design of your stencil. Its not the goal to decrease the tolerances. Take the PCB and take a look at the printing Shapes with microscope or use the zoom in 3D Function. If there is too l
Electronics Forum | Fri Sep 22 17:27:51 EDT 2023 | calebcsmt
How does one determine a cold joint seam vs simple cooling lines from solder cooling at different rates or part of the joint not reaching liquidous (very large pads)
Electronics Forum | Mon Sep 25 20:00:02 EDT 2023 | fuji_user_2014
I need to remove solder mask from a ground plane for rework purposes. What is the best method for doing this in the scale of 1000-1500 units? Recommended tools?
Electronics Forum | Tue Sep 26 08:42:29 EDT 2023 | carl_p
If your using Fids & not a board feature I would push it back to the board fab house & get them to cover costs. Give the board fab house a drawing of the board with acceptable tolerances etc. Never had had to use an offset with this method.
Electronics Forum | Tue Sep 26 14:24:49 EDT 2023 | dimamalin
Every year, an engineer from the local service center comes to us and performs the necessary maintenance and calibration.
Electronics Forum | Fri Sep 29 10:56:39 EDT 2023 | georgegr777
No I didn't. Where are they? Where I have to check?
Electronics Forum | Fri Sep 29 11:08:41 EDT 2023 | carl_p
I'm not familiar with that machine type but I would assume on the board that is flashing with the fuse fault? Could you not try swopping the boards from the other machine to prove it as the board, do you not have the manual you can check the fault
Electronics Forum | Tue Sep 26 11:45:06 EDT 2023 | inostranec
Приветствую. У нас была проблема с таким компонентом, он оказался с прямоугольной серединой, именно по середине сопло захватывает компонент. Нужно подробное фото компонента.