Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Wed Feb 28 00:01:47 EST 2007 | Muhammad Haris
Hi, The distance between the two terminations/endings/pads of 0603 (0201)is 0.15mm i.e. lesser than than the distance between the 0603 and through hole i.e. 0.5mm My ques is that, then why its termination doesnot short as it has a minimum distance.A
Electronics Forum | Wed Feb 28 23:21:54 EST 2007 | jmelson
Thanks for the data. That looks like the numbers I've seen, but the machine I have bid on (gulp) is an 84 with no suffix. I doubt that changes the dimensions, though. But, what I am trying to find out is if covers and panels can be removed to thin
Electronics Forum | Thu Mar 01 19:27:48 EST 2007 | Wayne
Yes, I am currently using Viromet 347 at the moment for my SMT lines. 100-150, 35 sec 150-207, 40 sec 207-above, 80 sec peak temp: 225 deg C. It is compatible to SAC paste in term of solderability and wettability. But in term of mechanical property (
Electronics Forum | Thu Mar 01 22:21:06 EST 2007 | davef
From our notes ... An intense evaluation was completed in 1992 that involved testing of three board types [6 layer FR4, 6 layer ceramic copper thick film, and a 4 layer copper-invar-copper board] by the Navy Surface Warfare Center, Crane, IN. [Obvio
Electronics Forum | Fri Mar 09 12:41:56 EST 2007 | coop
I have recently been handed over the waving operation here, and am unclear on how to address our recent issue with our Wave. We are using AIM WS-715M Flux in a Foam fluxer, and are using AIM SN-100C in the wave. The problem is on several of the assem
Electronics Forum | Fri Mar 16 16:21:30 EDT 2007 | bvdb
Our 1989 Fuji IP1 seems to have developed a personality. The most recent behavior change is that it now stops occasionally and takes a short "break". This happens just before the nozzle Z axis goes down - just before picking a part or just before
Electronics Forum | Mon Mar 19 17:09:38 EDT 2007 | jmelson
A binocular microscope gives just a little more info than the video would, as you have views from two slightly different angles. A good stereo microscope gives more resolution or sharpness than video can. You have to take the time to set up the eye
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Thu Mar 22 06:28:08 EDT 2007 | Hussman
Anyone ever design an external thermocouple that connected back to an enclosed PCB? If so, how did you make the interconnect or solder joint to the board? Did you change metals to a solder friendly material? The problem we have is an external t-