Electronics Forum | Wed Jan 21 10:27:27 EST 2009 | gidster
Ok. As you know the machines changed a bit after > 95 due to CE regulations. > > There are no drawing > on board/box level in Panasert > machines. > > However normaly i`ts the 100 volts > thats "shorting out" the machine and shuts it > down. C
Electronics Forum | Tue Mar 03 03:02:17 EST 2009 | emmanueldavid
25% out of Lands in PCB, Insufficient/Inconsistent Alloy deposition which causes for poor Tackiness between Device Spheres & Paste deposited. Also note that Aperture Opening Designs in Your Stencil draws a huge role for these defects. 4. Placement: P
Electronics Forum | Mon Mar 09 17:42:56 EDT 2009 | smellew
ok Please power on the machine & confirmed that M1CP 2 is ok this is the breaker for the 35V & check M1cp1 now look at the drawings at address 1011 & check the axis ready relays Z1 11CS3x 151-GB Closed is ok if open see address 5402 Z1 servo amp is f
Electronics Forum | Tue Mar 10 15:24:28 EDT 2009 | smellew
Rodrigo, I'm not available tonight, if you have a new servo amp change it pay special attention to the jumper settings there are 2 types of amp you can fit see drawings for info. the original info you posted, re the MTU i believe is not related but
Electronics Forum | Fri Apr 03 02:15:23 EDT 2009 | roy1209
I've heard from my company's engineer that it'll be better to use Gerber format if there's some impedance control line . Because usually Gerber has code numbers in data and someone can easily refer to controlled line on the PCB and ODB++ doesn't have
Electronics Forum | Tue Jun 02 17:45:46 EDT 2009 | boardhouse
Hi Nicoleta, As a board shop, either are good choices but in my experience with my customers ENIG has alway been the favorite due to it is easier to work with in regards to not having to tweak your equipment. As long as the board shop that you are u
Electronics Forum | Sat Mar 20 15:59:13 EDT 2010 | emanuel
I have a big problem in setting an smd inductor camera recognition. None of the existing options in the software version 0.99B sems to work. The part is a 6x6mm with chamfer corners of 1mm on each side, looking more as an octagon. Not only this, the
Electronics Forum | Thu May 27 18:40:02 EDT 2010 | dcell_1t
Hi. I'm trying to develop a shape to place a QFN at a CP6, I'm using FujiFlexa. We have never had a shape for this particular component, we only draw as a rectangle and put a rectangle vision No (10 in this case) but we're scarifying accuracy. is th
Electronics Forum | Thu Oct 07 08:13:52 EDT 2010 | remullis
I just swapped from the HASL to Immersion Silver mainly because the board house we use could not maintain consistency in keeping the pads level. I was constantly battling bumps and bad finishes on the pads. They are able to give me a consistent board
Electronics Forum | Thu Jan 13 20:40:47 EST 2011 | eadthem
properties > settings > troubleshooting > Set hardware acceleration to NONE > apply OK apply OK reboot. without this any attempt to take a screen shot of the program will not save the image (because in a fruitless attempt to speed it up they have pr
