Electronics Forum | Tue Jul 17 22:32:30 EDT 2001 | CAL
One Inspection Unit was from Original Solutions. It was mid way through the line near the Fuji machine. If this is the system contact Mike Feld at OriginalSolutions.com The give away did no require sophistication and dont think there was two AOI unit
Electronics Forum | Wed Jul 18 08:16:59 EDT 2001 | Aaron Squires
What experiences have you had with flex circuits and what methods reducing strain relief are most common? Currently, we are using a epoxy to doctor strain by running a bead between the flex cable and the PCB. Also, we are covering the solder joint.
Electronics Forum | Wed Jul 18 18:07:11 EDT 2001 | trgedlin
We're looking at buying some new hand insertion slide lines here, and I was curious if anyone had any suggestions. Of course cost and footprint size are important. What we have now are mostly home made and we're looking to improve. We do a medium
Electronics Forum | Thu Jul 19 08:45:44 EDT 2001 | danl
Dave is correct that AEGIS has a line balancing module to its CAM software called CircuitCAM if that is something you are looking into, however, the number Dave gave is a few years outdated. The new number is 215-773-3571. Or visit our website at h
Electronics Forum | Thu Jul 19 08:04:04 EDT 2001 | dahsr
I have a sealed and refridgerated 350g jar of solder paste (water soluable flux). According to the label it expired July 1st. 2001 after the 6 month shelf life. Can this be used? Why or why not? What is the relevance of the expiration date? Can I re-
Electronics Forum | Wed Jul 25 16:06:35 EDT 2001 | cnotebaert
As Dave said you should be concerned about separation. If you open the jar and see that the flux has separated from the paste ditch it. I guess I am a little more hesitant than others, I would discard the material and use fresh. You have to way the c
Electronics Forum | Tue Jul 31 12:29:48 EDT 2001 | neil
This goes back to the duplicate posting problem. The admin functions for the forum were not working properly so the duplicate postings had to be deleted manually. This caused discrepencies because the count information was stored seperately and didn'
Electronics Forum | Mon Jul 23 10:21:50 EDT 2001 | caldon
Since we use tons of different fluxes and chemistries we clean often. A quick trip to our batch cleaner- run one cycle.....back to the bench. We have no control just a weekly thang. When the sponge starts to deteriorate then it is replaced. Caldon
Electronics Forum | Mon Jul 23 20:15:48 EDT 2001 | davef
A minimal ventilation rate is 0.05 cfm per square foot, as recommended by the 1998 International Mechanical Code. However, this may not take into account other potential building contaminants from such sources as propane forklifts, which require a mi
Electronics Forum | Thu Jul 26 14:55:17 EDT 2001 | mparker
Why not a stink bomb during regular work hours? (If you can get any methyl mercapton, that stuff is very odorific. Smells like baby's barf. A little dab'll do ya!) That way you could gage the complaint ratio as time goes by. Could save you much elbow