Electronics Forum | Fri Jun 18 13:17:37 EDT 2004 | Steve
I would suggest first looking into whom your local distributor is for the Aim product line. Or for that matter any solder product Alpha, Kester etc. Does the distributor stock the product at all times? I find that alot of Manufacturers and their reps
Electronics Forum | Fri Jun 25 08:55:47 EDT 2004 | Vincent
Hi, I am tasked to implement process change in our mfg floor. And one of the big problem that I can see is that to change a company culture where QC dictates the process and inspects every PCB. From what I know QC conducts random Inspection and oper
Electronics Forum | Sat Aug 07 01:04:40 EDT 2004 | rsgupta
Why not.. You are always welcome. Firstly what I feel multicamera system (Top and Angled) AOI is always better than single Top camera system in terms of defect coverage. Secondly read On the fly inspection is much better than STOP and Go techniques.
Electronics Forum | Tue Jul 06 16:59:36 EDT 2004 | davef
I'm sorry for not being clear. The "1 thou" refers to the thickness of copper that rides below your ENIG. If your HIC card is blue that's good. If it's some other color that makes you nervous, then you make of it what you will. They're pretty muc
Electronics Forum | Fri Jul 09 11:57:56 EDT 2004 | Chris Lampron
WA Engineer, If you are able to change over to OA instead of RMA, you can clean effectively with DI water. (I know that some Military contracts specify RMA) Most systems are designed to filter the waste water of ionized contaminants before dumping t
Electronics Forum | Sat Aug 07 04:11:57 EDT 2004 | AOI Solution
This is Ivan from TRI USA located in Santa Clara, CA Our company provide a Solder Paste Inspection System which uses 635 Line Laser to scan the panel and come out a real 3D height, area and volume measurement! We sold lots of this system in Asian EMS
Electronics Forum | Mon Jul 19 14:58:50 EDT 2004 | mattkehoe
We have a need for expert opinions on a solderability issue. Our company prints and then reflows solder paste with no components in place. It is then washed and flattened with a special flattening machine. Usually, the paste fuses and spreads out
Electronics Forum | Mon Jul 19 16:26:09 EDT 2004 | davef
Your fab has supplied you with unsolderable boards. They are dewetted, due to some process problem. That they are dewetted on the annular ring of the via indicates that the problem is with the board and not with your paste. [We assume you do not p
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Mon Aug 09 10:30:25 EDT 2004 | AJ
celldude, I have a couple more questions for you. Where can one look into getting these machines necessary for SSD? Also, knowing that the machines are expensive..Does your company find they are saving money (in the long run) by using SSD? More spec