Electronics Forum | Tue Dec 07 07:26:50 EST 2010 | grahamcooper22
In an oven over 100 C any moisture will escape through vents. There will not be huge volumes of moisture in the oven when you are baking components so it should easily escape through vents / holes in the system leaving you with a humidity of near zer
Electronics Forum | Thu Dec 16 20:00:53 EST 2010 | jeffr
Tom, If you need the parts... I can quote and supply them.. A good tradesman can change these parts. You do not necessarily need a Yamaha trained guy to do it. The only issue issue after the exchange of the parts is calibration of the machine, which
Electronics Forum | Mon Feb 21 08:44:10 EST 2011 | kahrpr
They all are inlineish They just carry the board to the vapor chamber. in a reflow system all the boards in the oven from beginning to end are in state of process, which gives you more speed. If the board has a long cycle time VP is not a problem. If
Electronics Forum | Mon Feb 14 10:06:50 EST 2011 | cecchetti
from expedition 2005.3 design environment i must generate the fabmaster for the Oka-no testing system. I have a problem because Oka-no can't read the fabmaster file generated from Expedition. The fabamster generated from Expedition has a format more
Electronics Forum | Fri Apr 01 00:30:45 EDT 2011 | bigvern
Hi, we have a issue with a Dage , Xray, curious as to if any other have had same, we cannot get the the Vacuum level in the tube to the correct level, it builds up and builds up, but never reaches correct set point so that we can calbrate or use the
Electronics Forum | Tue Apr 19 15:20:30 EDT 2011 | rdoss
My company will be purchasing an AOI machine within the next 3-6 months and we are debating between several manufacturers and between "Golden Board" & "Algorithm" based systems. I've had some experience with YES Tech and have seen a couple of each k
Electronics Forum | Mon Nov 21 18:39:55 EST 2011 | khid
i've been in manufacturing for 15 yrs. I used AOI with match patter as well algorithm base in one machine. Easy to program, can built in global library based on your cspecs or part number use in the manufacturing line. ROI can be achieved in the shor
Electronics Forum | Wed May 04 06:06:34 EDT 2011 | clampron
Good Morning, I have been working with a company that has a selective electroplate touch up system from Rapid Electroplate. They have used this for repairing gold electroplate. Scratches and in some cases, replating pads that had been contaminated w
Electronics Forum | Fri Jun 03 14:33:16 EDT 2011 | sunrotor
Amen... Until the process is designed, documented, employees trained and proficient, equipment maintained and calibrated, parts issues resolved, programming corrected, attitudes adjusted, and timetables reasonable, there is no need to tweak the inspe
Electronics Forum | Fri Jun 10 13:04:04 EDT 2011 | spitkis2
Any suggestions as to what can cause a PBGA's corner to warp down during installation process on a rework system? A couple solder balls bridge at the corner. It appears at the pin 1 corner where the metal indicator of a BGA is exposed. I am wonder
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400