Electronics Forum | Thu Aug 31 10:57:24 EDT 2006 | slthomas
Is it possible that he was testing you to see if you knew whether or not 610 addressed environmental specs? I had a consultant that was touring our plant ask me what aspect ratio we used on our stencils. I told him I like to keep it at 1.5 if I can.
Electronics Forum | Tue Sep 05 08:40:33 EDT 2006 | CL
SMAINTECH, Good Morning, We have installed the Gridlock tooling pin with stealth mode on our DEK's. It is a hard tooling pin array that resets the height if the pin for every board. The pin comes up until it comes into contact with something then lo
Electronics Forum | Fri Sep 08 11:38:42 EDT 2006 | GS
Last april,I have seen same behavior on a pot using SACX. Phenomena happened just few days after start up of a brand new solder wave. I know they have got the pot replaced but I do not know what about the new pot if had same problem. I know they mad
Electronics Forum | Fri Sep 08 10:16:24 EDT 2006 | slthomas
We had problems with Panasonic film caps with a previous employer. The first step was to use their recommended pad layouts rather than industry standards for the part sizes. The second much more helpful resolution was to complain like hell to Panaso
Electronics Forum | Fri Sep 08 11:29:40 EDT 2006 | GPP
James, What type of profile are you using. Ramp-to-Spike, Ramp-Short Soak-Spike, or Long-Low Spike? I had a similar problem in a past life - random skews on chip components - and got rid of it by converting to Ramp-to-Spike (the old profile was R
Electronics Forum | Fri Sep 15 11:38:19 EDT 2006 | scott
I want to thank you for your help. MPM SN's are continuous (7001 to the more current 7780's), no date included. I had already contacted MPM and their Technical Support personnel could/would not pin-point the year it was manufactured, hence the reas
Electronics Forum | Wed Sep 20 16:01:52 EDT 2006 | jimmyjames
We recently upgraded our SMT placement equipment and are quite happy with them. One of our old SMT machines however had a glue head attached to it and we are now in the market for a standalone glue station. Our SMT placement rate is roughly 12k CPH
Electronics Forum | Mon Sep 25 16:31:41 EDT 2006 | SWAG
We are just getting into full production on a handful of lead-free builds. We are finding that the specific lead-free paste we are using is very susceptible to shelf life and dwell time. Much, much more than our experience with leaded. We have had
Electronics Forum | Wed Sep 27 12:46:42 EDT 2006 | John S.
Steve, We use the 955 version for printing with the DEK Pump Print process on two lines in high volume. We clean the stencils in an ultrasonic bath with Hydrex A+ I think diluted in deionized water at the end of 2nd shift. By startup, they are dry
Electronics Forum | Wed Sep 27 15:57:33 EDT 2006 | SWAG
I wanted to post resolution on a reflow oven problem we had but can't seem to search out the old thread. So, this is new but old. Our OmniFlo 7 conveyor was stopping every once and a while and the speed indicator on screen said 1000+ ipm. We cle