Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon Oct 07 22:06:43 EDT 2013 | action_101
I successfully inspect solder on plcc's with angled cameras on the yestech we have. In the past I have successfully inspected for solder with angled cameras on mirtec machines for both plcc's and qfn's. Other than inspecting solder on those two types
Electronics Forum | Wed May 22 19:47:30 EDT 2013 | anvil1021
Also, I was just thinking that most of the large companies we work with do not consider via drain an actual void. As a matter of fact our high dollar super fantastic Xray system actually has a switch to turn off the vias during void detection so that
Electronics Forum | Tue May 21 15:37:36 EDT 2013 | armelinda
I am looking for a service providing non contact PCB flatness measurement for open board SiP assembly. It was returned for failure analysis with complaint that assembly does not solder properly onto customer system board. Since there are remnants o
Electronics Forum | Thu Jun 27 14:56:05 EDT 2013 | kdc45
Purchased 2 used Fuji CP43's and did not receive manuals with them. Have been using CP42 manuals to write procedures and looking for jigs for the vision systems to calibrate them. However, I cannot find the jigs with the part #'s that are in the CP42
Electronics Forum | Tue Jul 02 09:05:56 EDT 2013 | dporada
I am trying to run AutoProgram for the first time and I am having trouble running it. I created a Windows 95 virtual machine on my laptop and installed the software. When I ran it, I got a Foxprow error. When I click the ignore button, I got a sys
Electronics Forum | Tue Jul 16 18:05:29 EDT 2013 | Mike Konrad
This was built and sold by Trek Industries. Several years ago, Stoelting purchased Trek. I believe the machine is now discontinued. I am not sure if they continue to provide support. Here is there contact information: PW STOELTING, L.L.C. A VOLLRATH
Electronics Forum | Mon Aug 12 15:56:13 EDT 2013 | pjchonis
Vapor phase soldering systems by Asscon are characterized by special designed heating modules. The thermal mass of the heating modules is designed so that a completely delay-less and direct regulation of the heat/flow/energy transfer to the soldering
Electronics Forum | Thu Jul 25 12:15:56 EDT 2013 | ericrr
I was flicking through the "Element14" (previously known as Farnell) BIG catalog (looking at the pictures) far superior to looking via internet. and found the closest to what you are after a five pin version. "Battery Interconnection System" Header,
Electronics Forum | Fri Jul 19 10:01:30 EDT 2013 | dontfeedphils
In a past life I ran F1 systems post placement / pre reflow behind a MyData My12E, so it didn't exactly have to keep up with a speedy chip shooter, but it did pretty well. The AOI would end up being the bottle neck some of the time, but not because