Electronics Forum | Thu Oct 29 01:09:25 EST 1998 | Pete Sorenson
| Does anyone know where to get conductive coatings you can spray/paint/bake on hard surfaces? I would like tha actual manufacturer not a coating service company. | I used products from Acheson Colloids with good results for many years. Phone 800-2
Electronics Forum | Tue Oct 27 12:22:34 EST 1998 | Sanjay Bhatikar
Sirs, what would be a good way to judge the reliability/robustness of a stencil printer or chip shooter? Does any equipment supplier specify detailed maintenance schedules? Is there a source of machine failure data (MTBF, etc.)? I not
Electronics Forum | Tue Oct 27 09:52:37 EST 1998 | SMD
I need new mats that would be suitable for moving feeder carts across. And I need them tomorrow! We just pulled out the old ones to allow for installation of a new line and the old stuff isn't looking so pretty. Please help. Scott Davies Performance
Electronics Forum | Wed Oct 28 11:51:08 EST 1998 | Dave Hattas
Dave, I am the local Quad Area Rep; please call and I will help you with information on Quad systems and offer references. Quad has over 3000 machines installed and last year did over $80M in sales. | Does anyone have info on any of these systems
Electronics Forum | Mon Oct 26 19:10:52 EST 1998 | John Vaughan
I'm trying to find a source for a tilt device for use when doing touch-up soldering. Employee needs to raise the board above standard bench height for better access to the board and for better posture. Angle of the tilt device should be adjustable;
Electronics Forum | Mon Oct 26 14:20:49 EST 1998 | Paul Brydges
Hi, My question is how close can you place smd 0603 chip resistors to each other with having an assembly problem? I know the pick and place machines don't need a lot of clearance, Iam more concerned about the court yard area around the component to
Electronics Forum | Mon Oct 26 01:37:43 EST 1998 | Samson
I'm very new to the SMT process but I'm tasked to qualify a MPM Printer and a Panasert PnP m/c. The product consists of 6-10 different parts of a total of around 70. Please advice on the parameters for each m/c which I should focus on for optmization
Electronics Forum | Sun Oct 25 08:10:49 EST 1998 | Cunli Jia @ SMTnet
George, Please visit the SMTnet First Chapter Bookstore via the link "Bookstore" in the left munue or below. Many books have a full chapter online for free preview to help you decide to buy or not. Please post to the Admin Corner or e-mail me dire
Electronics Forum | Sun Oct 25 03:11:13 EST 1998 | Paul Ramsey
Can anyone help me out? I am looking for any information on In-line automatic optical inspection systems for SMT (not Bare Board). Does anyone have any thoughts which equipment is ok? I have visited MVT & cyberoptics sites but i would like more detai
Electronics Forum | Sat Oct 24 07:55:55 EDT 1998 | Chuck Garth
I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility getingthe heat seal ribbon to make consistant electrical contact. Any help would