Electronics Forum | Tue Jul 19 09:06:00 EDT 2016 | davef
We used to use those, back in the bad old times. basically, it's a router with a blade on it that is used to trim the leads of PTH components that are mounted on boards. Nasty process. Difficult to control. Messy, firing cut leads all over the plac
Electronics Forum | Thu Aug 18 09:46:40 EDT 2016 | jbuckley
Put anything over one of the fiducials being used in the circuit, and run the board. It will stop, and on the top right a window will pop up. Click "Skip Current Module" and it will X-out that circuit. If you are using the fiducials on the rail, rath
Electronics Forum | Sat Nov 05 20:04:40 EDT 2016 | sarason
You would be better off setting a new fiducial using a pad or other feature that would serve that purpose. If the board has not etched correctly, it is better to bad mark it and not use that board on a panel. Safer in the long run as it may have othe
Electronics Forum | Wed Jan 25 18:59:49 EST 2017 | superlen
When the fiducial fails, the machine stops with the crosshairs near the fid that couldn't be read. On the CP45 you just jog to the center and tell it use the position you just navigated to. (the manual correction). I believe the cp40 is the same...
Electronics Forum | Wed Nov 09 09:08:40 EST 2016 | sumote
We are currently running FUJI XPF lines and > receive all of our RF shields in T/R format. > The large shields we use come on a reel of 500, > the small shields come on a reel of 800. both > much more efficient than using trays. I agree. Get
Electronics Forum | Tue Jan 10 02:17:29 EST 2017 | soldertraining
Hi ! I am also looking for the same and I am aware of this little like the -selective solder machines are generally cheaper to run due to the reduced amount of flux and solder being used and it’s possible to use a solder with no silver content and st
Electronics Forum | Fri Dec 02 08:52:22 EST 2016 | johnwass605
Has anyone had any experience using EMC Global Technologies for wave solder pallets, reflow fixtures or workboard holders? I am thinking about using them and would like to know how there quality and service is. Also how are there prices? Would you co
Electronics Forum | Fri Dec 02 22:51:23 EST 2016 | peteralmendrala
Hello, im using Siplace X2, i have problem im using inkspot. My inkspot is color black. When manually inspected to the machine it can detect correctly, but when i run it in auto, still the machine mount the component in a pcb that has a inkspot. Nee
Electronics Forum | Tue Dec 27 10:18:03 EST 2016 | anhsang38
Dear Pro, I want to confirm with you about conveyor speed. is 1m/s? We are using wave soldering but it is 1.2m/min, min not second. Pls, check it agian. The flux is not relative this error. It is relative no sodering, bridge. The solder bar is the
Electronics Forum | Tue Jan 10 08:05:51 EST 2017 | tombstonesmt
That is literally twice the amount of work. The drawing would've taken 10 minutes tops. I would've gone to lunch and that would've been done printing. We have a 3D printer in house as well using ESD safe filament. We've used it for tooling, prototyp
