Electronics Forum | Tue Feb 21 10:15:07 EST 2012 | vinitverma
Forgot to mention. To disable the LCS you need to disable it in the machine config - by changing Tray Changer to NONE. Of course for this you will need the password which is "specialist". After setting this in the software, you also need to remove t
Electronics Forum | Mon Jan 21 09:54:22 EST 2013 | ngineer
Bobpan and all future people with this problem, GOTO 0 Fixed the problem. It also counts boards now. I never knew why it didn't count the boards run. Haven't looked in the manuals, but I would bet that it shows this plainly. This makes sense,
Electronics Forum | Thu Mar 29 02:46:25 EDT 2012 | johndoe0222
My company is doing a project with a lot of QFN. The question that we are not sure is how to properly solder a QFN on a PCB. QA says The alignment tab on the side of the QFN should have a physical solder from the board, like a leaded chip. After refl
Electronics Forum | Thu Apr 05 11:48:25 EDT 2012 | pbarton
Are you running individual point soldering on each component lead, of are you drawing lines with the solder fountain to increase the speed of the process? Could be that if you are drawing lines, coupled with the very low flux levels you say you are
Electronics Forum | Mon Jun 11 17:47:54 EDT 2012 | tombstonesmt
Pete B *We do lines of soldering @ 10mm/sec *Similar solder balls were present on product after soldering. *UPDATE SOLUTION* We began using topside preheat while fluxing the board to reduce the thermal shock factor in addition to replacing the "fi
Electronics Forum | Mon Apr 23 07:28:42 EDT 2012 | ccottreau
Has anybody any experience in cleaning the Jupiter 32 LGA in a Aqueous cleaning process (or any kind of shielded GPS Module). The manufacture does not recommend Aqueous cleaning because that length of drying time and that this may leave residue on th
Electronics Forum | Thu Apr 26 16:36:35 EDT 2012 | davef
Stencil Cleaning [AIM LeadFree] * Stencils should be cleaned frequently enough to ensure total removal of any bottom side residues, but not so infrequently as to allow the same residues to dry or cake on, making their removal much more difficult. * S
Electronics Forum | Tue May 08 16:00:55 EDT 2012 | scottjwarren
The Dima PnP machines look really nice -- exactly the size and capabilities we will need for the next 3-5 years. Apparently, however, they are supported in the US by Manncorp. I have nothing personally against Manncorp, but have heard bits here and
Electronics Forum | Mon May 07 10:42:09 EDT 2012 | saju86ece
Hi, I need one clarification about solder paste printing height tolerance. How to define and fix the solder paste height tolerance after screen printing for inspection purpose. Currently we are using 5mils thickness of stencil, in that we are gave
Electronics Forum | Mon Apr 08 00:06:58 EDT 2013 | toddmahon
Have you had any luck? I just purchased the same machine and it has some kind of a boot error. After power up a screen pops up in Japanese with English sub titles. In the bottom left corner it reads Memory Card Data Error - Load Data. I connected to