Electronics Forum | Sat Feb 18 20:46:45 EST 2006 | Brian
Hey, Been looking at Brisbane, hoping there is enough SMT going on to be able to get a job there. Noticed a lot of manufacturing seems to be in NSW though... Staying clear of Sydney due to cost of living and Perth due to remoteness. Where do y
Electronics Forum | Fri Feb 17 17:26:56 EST 2006 | mika
Hmm... how about the people inside this room; working in this dry environment? This is something never discussed highly, but I believe it is most certainly important for the human health. This is another interesting thing about RoHS; the side effects
Electronics Forum | Fri Feb 17 06:16:52 EST 2006 | bwet
Dear Collegues: We recently commissioned a laser machining center that is used on a job shop basis for a variety of customer work. Does anyone have a recommended procedure for completing a machine capability study? How about a recommendation on
Electronics Forum | Mon Feb 20 17:12:54 EST 2006 | mark
Hallo all, I have recently had possibility to work with DEK265. I have met with problem poor print definition (no sharp edges). I used stencil 150 thickness, metal squuegees. I moved than the same stencil, squeegee and parameters to DEK nifinty and
Electronics Forum | Fri Mar 03 15:20:16 EST 2006 | Wave Master Larry
WELL if that isnt a sales pitch I dont know what that was.At my place of employment the engineering department tried to make us use this gizmo for our waveprocess and managment was made to beleive that this was the cure all for our shorts and skips.W
Electronics Forum | Mon Feb 27 10:24:17 EST 2006 | actech
Thank you for these thoughts, So Concreate floors, ESD wax, heal and wrist straps, in applicabe locations, grounded ESD mats at work stations, and smurf outfits. should do it ? 10 the the 6th 10M 10 to the 7th 100M big differance what is the target
Electronics Forum | Thu Feb 23 13:56:21 EST 2006 | slthomas
I have dealt with it before and usually it's consistent, so you use some simple math to work around the issues. Now, if you have so much variability between different locations on your board for resist thickness, HASL thickness, etc., that it fouls
Electronics Forum | Tue Jul 25 18:49:32 EDT 2006 | ezra
Hi We have a service manual for the Topaz, but it does not have a section on using mount feedback. However, it does cover Auto Mount Feedback quite extensively. Sadly, we do not have a glass calibration kit, nor do we ever plan on investing in one, a
Electronics Forum | Wed Mar 08 08:37:24 EST 2006 | wbartley
Pavel First off I agree with Newton It sounds like the machine may not be level. Check all four feet while the machine is warming up none of them should be moving up or down. Chances are your right front or left rear foot is not at the right height.
Electronics Forum | Mon Mar 06 21:58:56 EST 2006 | kent_peterson
Good machine! Just like most part libarys don't let the operators change part profiles. Haven't seen it place 0201's but 0402's have no problem. Tape splicing for the feeders is a problem. The eject wheel gets jammed with anything other than splice t