Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Wed Jul 10 14:14:21 EDT 2013 | benreben
hi all, i have purchased an used vapor phase and i can't make a constant profile. the profiles depend on the time i wait between two batch... the only difference that i include is the chamber temperature i don't understand why the chamber temperat
Electronics Forum | Mon Sep 09 17:01:21 EDT 2013 | proteus
I wish I knew the MSL. The factory data sheet from 1995 does not list the specification. The moisture problem makes perfect sense for what I'm seeing. When we replace these parts by hand (no reflow) the failure rate goes down to almost non-exist
Electronics Forum | Thu Dec 12 12:54:25 EST 2013 | jaimebc
For selective soldered components, or even hand soldered, with vertical bend components, the body of the component, in this case a resistor, is making contact with the surface of the PCB, making it impossibe to visually see the solder fillet. Or to d
Electronics Forum | Fri Dec 20 06:12:17 EST 2013 | bandjwet
Jimmy: Make sure to look in and around the board to make sure you have captured all locations of solder balls/fines as they are commonly caused by the profile or print issues. If they are non-embedded and are a 610 defect based on the class of your
Electronics Forum | Fri Apr 25 11:15:48 EDT 2014 | hegemon
We provide similar maps for our teams as well. For this exercise, Frazz has it. Screen print and use Windows Paint with the spray can tool to make dots. I do it often enough to have gotten very quick at it. Or get a copy of the software used to c
Electronics Forum | Sun Jun 22 21:13:11 EDT 2014 | lilblevs11
I am new to programming these devices. I have programed quite a few things in my life from games to android apps to arduino to microprocessors. However, I have never ran into a MyData machine. Does anyone have any assistance or advice to help me lear
Electronics Forum | Tue Oct 14 10:21:44 EDT 2014 | fredc
Accuracy of the arbor press might be made better by tightening the adjustable gibs on the ram if any. If you can use support under the board have the ID of the support just slightly larger than the pins being pressed. Janesville Tool makes an accura
Electronics Forum | Thu Feb 19 19:08:02 EST 2015 | comatose
Ignoring the certification issue for a second, what is the alloy of those two joints? The melting temperature? The strength? And no. You added a single homogenous material (leaded wire solder) later in the process. Adding leaded solder makes it non
Electronics Forum | Fri Jul 10 08:50:04 EDT 2015 | jax
Is the feeder working properly... presenting the label at the same location each time it indexes? If yes, I would look at changing nozzles on the machine. sometimes a rigid tipped nozzle cannot maintain suction on thin items like labels that can ben