Electronics Forum | Wed Sep 20 17:24:35 EDT 2006 | Stano
I have problem with Panasert MV2VB. After activation machine start up Windows NT normally, well near end initialization displayed message: MMI initial check - Symbol 1 - 0 error. After initialization finish and Power On machine is dispalyed Self diag
Electronics Forum | Thu Oct 19 08:54:39 EDT 2006 | df
thanks for replies guys. I have a nearly Full RoHS Compliant bom with 1 device non-rohs. It is a soj28 device rated ( as best as I can find out at 225degC) Production are screaming for these boards - I put a thermocouple on the part and it hits 23
Electronics Forum | Fri Nov 17 15:12:26 EST 2006 | mds33200
Hi, I am located in Auburn Mass (USA) right near Worcester. Now I noticed you talked about micro stencil for a populated PCB, would I need one? Or could I use a syringe to lay a tiny dot of paste since im only replacing a chip or 2 (at the moment)? I
Electronics Forum | Mon Dec 11 06:29:04 EST 2006 | bwet
See before cversus after pics on BGA pad repair here: http://solder.net/services/services_pad-repair.asp The "how to" instructions for traces (and pads) is here: http://solder.net/solderingtips/PadandTrace_Repair_Solder_Tip12.wmv The skill level
Electronics Forum | Fri Dec 22 15:29:30 EST 2006 | mika
The same to You and everybody body else in this forum. I agree with You and looking forward to new challenges next near. I can not emphasize enough how much that this forum have been a lot of help to us. Sometime it has even been funny and we all n
Electronics Forum | Thu Jan 25 09:45:54 EST 2007 | SWAG
You might consider installing a noise kit as it sounds like you've tried almost everything else. Electrical interference on these machines causes erratic problems, especially as they get older. I would call Speedline tech. and see if they think the
Electronics Forum | Wed Feb 07 07:45:50 EST 2007 | jax
Water soluble residues probably won't cause instant failures. The failures are most likely caused by excess paste being deposited on the center pad of the QFN. The excess solder keeps the part from sitting down in reflow and increases the possibility
Electronics Forum | Fri Mar 23 03:53:44 EDT 2007 | Guest
Hi Bert , I dont know much about IP , since I partnered our Fuji CP 6 with Siemens .At any rate, can you check your flat ribbon cable of your Ip's Head. I assume there one wire that is nearly breaking. During movement, head servo controller experie
Electronics Forum | Mon Mar 26 20:04:04 EDT 2007 | Amy
Yes, I have tested some boards, and found that most QFPs which near the via will have the higher temperature. One of my customer requirement is to have the temp less than 200 deg C for top side. We were using the hi temp wire to solder the QFP's for
Electronics Forum | Thu May 17 03:52:34 EDT 2007 | kevinjm
Hi lads, I have a problem with asequencer 2596. We had a power cut last week which cut power to the seq. The battery on the controller box was dead(now replaced), which meant the exec file got deleted from machine. Now I can't load it back up again.
