Electronics Forum | Thu Nov 07 15:33:02 EST 2013 | mleber
Below are a few photos of an ongoing issue we are having with 1 pwb style. Some of the pads appear to have contamination that appears after the selective solder step. The joints are extremely hard to rework - almost impossible. We had the joints anal
Electronics Forum | Thu Dec 26 08:40:21 EST 2013 | vileo72
Hi , During one of NPI trial ,we found that boards ( CEM -1 grade )has got discolored on the masking portion ( and not on the conductors) after reflow .Although it does not impact our Form /Fit and Function characteristics , I would like to get your
Electronics Forum | Wed Jan 08 08:20:52 EST 2014 | emeto
To most of our boards I give 20-30% tolerance in both directions. From experience if you have big aperture on your stencil, the squeegee will scoop certain amount of paste from this aperture and you will see lower height. Depending on your board supp
Electronics Forum | Tue Feb 11 09:01:54 EST 2014 | emeto
You should get your paste in ice(dry ice). Then you should keep it in a fridge. Many pastes now have 1month shelf life(after you take it out of the fridge). If you follow all the above, you might be having: 1. Lot problem - try different lots of you
Electronics Forum | Wed Mar 12 10:04:20 EDT 2014 | globalpowerproducts
We had a SMT specialist come in and go over everything we were doing wrong! We were dipping the boards rather than spraying them, had the pre-heaters set way to low, the conveyor was going too fast, and the actual wave was in the machine the wrong wa
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Tue Mar 25 15:16:16 EDT 2014 | yuran111
machine controller BIOS loads only cyclically until pressed reset button on it - now checks the configuration and loading tasks load. hard drive I can take from the controller Siemens s27 example? motherboard came from s27 machine, and the same softw
Electronics Forum | Sun Apr 13 02:36:06 EDT 2014 | alexeis
Hi, We have system called Setup Center for Samsung that can give a solution to your needs. It loads samsung files, including before and after optimization, and gives you feeder list splitted by machine and side (Front/Rear). Also, you can go over on
Electronics Forum | Thu Apr 17 14:01:26 EDT 2014 | hegemon
And digging a bit further, are the opens at the device level (all the solder on PWB pad, none on device pad) or at the PWB (similar to pillow defect?) After answering that, I would start thinking about(in this order)paste print quality and consisten
Electronics Forum | Mon Apr 28 15:20:50 EDT 2014 | davef
Your customer is correct. Your supplier has clamped some sort of machine to your butt and has plugged it in the wall outlet. Honest mistake: * IPC-A-600H, 3.3.2 Lifted Lands - (Cross Sections) ... pertains to boards that were cross sectioned after t