Electronics Forum | Fri Sep 22 14:10:19 EDT 2017 | slthomas
Just for the sake of passing along the information, the fine grained stencil provided zero improvement over the standard PhD stainless and was not nearly as helpful as the baked-on nano-coating. We probably won't be trying that again unless we go und
Electronics Forum | Fri Nov 10 22:31:27 EST 2017 | myke03o
Hi, we are experiencing insufficient solder and bridging solder. Any recommendation on the inner pad (LGA) and stencil thickness. Any suggestion will be very helpful. link: http://www.latticesemi.com/~/media/LatticeSemi/Documents/ApplicationNotes/
Electronics Forum | Fri Dec 01 09:29:36 EST 2017 | kojotssss
Hello. We have a problem with QFN type. Component is elevated. Stencils are reduced. Vias is without holes. What are the solutions to fix the fault. Look at the photo. Attachment: https://drive.google.com/open?id=1OIgaXUz2yoKP3fWZg2rUsrmZMBWidk6_
Electronics Forum | Tue Nov 28 10:48:29 EST 2017 | georgetruitt
Some things to look into are the component finish, material and composition of the solder, design of the smt stencil, reflow profile or process atmosphere (N2 or air)also contribute to the solder result. The influence of the PCB itself should be co
Electronics Forum | Mon Feb 26 22:16:47 EST 2018 | reckless
I just saw an ad for a Yamaha IPULSE M20 SMT placement machine. Is there any other manufacturer doing this? I like removing unnecessary steps from my production line. Here is a youtube video: https://www.youtube.com/watch?v=CfwBulvV0i8
Electronics Forum | Thu Jul 19 21:41:37 EDT 2018 | teresat2
Hello Andrew, This is Teresa form allpcb. ALLPCB is a topspeed pcb manufacturer in China, specializing in high quality and cheap pcb prototype & production, pcb assembly and smt stencil services online. We are in China not Austrail, but if you can g
Electronics Forum | Wed Apr 11 14:41:29 EDT 2018 | charliedci
We have used DEK for over 12 years, can remember only a handful of times they mis cut a stencil and have always stood up and replaced at no charge with no argument. Have missed their "same day" shipping a bit of late, but overall we're very satisfied
Electronics Forum | Thu Apr 12 08:14:43 EDT 2018 | cyber_wolf
The way to determine correct pressure (in my experience) is to start out at what you would consider to be a low sq. pressure setting. You are looking for it to leave a slight film of paste on the stencil. Start increasing pressure in small incremen
Electronics Forum | Fri May 11 20:55:51 EDT 2018 | jlawson
Rehm Thermal Systems (Germany)offer in process vacuum reflow in convection ovens and vapor phase pending what makes sense - volumes of PCB per hour needed. There are other vendors getting into this of course. Can only get single digit void free join
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st