Electronics Forum | Fri Jan 30 09:29:22 EST 2004 | caldon
Joe- You confused me In the subject it has SMT and in a posting you say Through hole components. I was incharge of getting equipment for a research and teaching facility called ACI (Some know it as the EMPF). I was tasked with getting equipment at n
Electronics Forum | Wed Mar 31 10:16:01 EST 2004 | caldon
Being a former Apps Engineer I hear what yer saying. The 10" Leg Screw was hypothetically speaking about Siemens Machines. Since they do go lower the need for a 10" leg screw is needed. They do not use a 10" leg screw they use platform feet risers in
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
Electronics Forum | Wed Jun 23 13:37:12 EDT 2004 | bbarr
We have had an RTX-113 since 1997. I echo Cal's comments with respect to experiences with the unit and the desire for the angle viewing. Don't know if the angle viewing is available on the RTX-113. You should look at a unit with that option before ma
Electronics Forum | Thu Jun 24 09:19:31 EDT 2004 | Cal
The Angle view (or Variable Angle Viewing) gives you another perspective on joint inspection. Glenbrook has two great illistrations on the varible angle viewing literature (.pdf file): Here are a few examples: 1) Looking straight down on the ball..it
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Wed Oct 13 12:52:52 EDT 2004 | caldon
I do know for our case...it was not just SMT manufacturing. There were many variable: 1) Part purchasing- The larger CM's would get better $ and lead times than we could. in some case we would have to wait 4-6 months before delivery. Or we could buy
Electronics Forum | Thu Feb 03 13:23:30 EST 2005 | caldon
Hi Steve- We have a Glenbrook system and are pretty pleased with it....as far a value vs. cost it works great. I did have an issue with a Soic with a ground plane in the center...yes SOIC!!! The Ground plane was a heat sync that had vias for thermal
Electronics Forum | Mon Jul 18 01:23:23 EDT 2005 | Cal
In regards to your post...I am sure Autotronk is the manufacturer. I can only asume when you speak of a "local Rep" it is in the US. If you go to Autotronik's website via the link you provided...you will see Manncorp is the Canada/USA/ Mexico Rep. He
Electronics Forum | Tue Apr 11 15:37:31 EDT 2006 | stockley
(Hey Cal how you doing?) I can't resist this. You can sort of do what you're hoping for but you have to be very careful. Let the component run out and let the machine get as far as it's going to go. Then go to "Software Options", "Test commands" then