Electronics Forum | Tue Nov 04 12:04:48 EST 2003 | Randy Teadt
I represent a company Sony TiMMS that provides exactly the tool you are looking for. It is specifically designed to track realtime consumption in order to provide JIT solutions in the ELectronics Industry. SOny has used this internally for over 13
Electronics Forum | Wed Nov 05 08:24:16 EST 2003 | Paul O ' Connor
When reflowing a Vishay PowerPak SO-8 & using the recommended footprint from the data sheet, the component is skewing in reflow, to solve this we have to add a glue dot to both sides of the part, will making the PCB land pad 1:1 with the Solderable
Electronics Forum | Wed Nov 05 08:45:13 EST 2003 | Marc V.
I am trying to figure out how many feeders I will need for our first venture into SMT. I have broken down our largest board we would build into the different feeder types. What I need to know is, how many extra should I order? Why?
Electronics Forum | Wed Nov 05 13:45:21 EST 2003 | Marc V.
Money is not a problem, I am more concerned with ordering the appropriate amount from the start. It doesn't have to be exact but close so I can do all of the off-line set ups and etc; At the same time I don't want to order double the amount because t
Electronics Forum | Sat Nov 08 10:32:58 EST 2003 | kauerr
IF someone wants to sell me a brand new SUV valued at $40,000 for $500.00 and I buy it, it does not mean I stole it. Nobody made Cookson sell Speedline. If they did not like the offer, they would have waited for a higher one. Seems like You are upset
Electronics Forum | Sun Nov 09 01:58:09 EST 2003 | fastek
Oh Primus I didn't mean it literally! And it doesn't upset me at all. Amazed perhaps but upset....no. The bottom line is either the market is far worse than suspected or Cookson simply had no idea how to run and manage perhaps the best collection o
Electronics Forum | Fri Nov 14 08:28:22 EST 2003 | caldon
Actually cleaning of PCB's may see a resurgence with the lead free movement. Higher temps and more aggresive fluxes might need to be clean depending on your board and process. In addition Wave soldering solder pots (in some cases machines) may have t
Electronics Forum | Wed Nov 05 13:43:52 EST 2003 | swagner
I just did a bga job with square aperture's, the reasoning is for enhanced print release and additional paste volume. Be careful of the edge to edge clearance between the stencil openings, I don't recommend going below a 8 mil clearance, you could b
Electronics Forum | Wed Nov 05 17:36:12 EST 2003 | Stephen
Make sure that the side of the square is the diameter of the pad, That is that the circle is inside the square not that the square is inside the circle. normally the aperatures are smaller than the pad to get gasketing. In this case the idea is to
Electronics Forum | Wed Nov 05 19:57:35 EST 2003 | Hoss
9.0. In it's spent form (from a batch cleaner) the cleaning solution is at a pH of 10.1. Luckily, we are setup with a holding tank and have an oppurtunity to treat the stuff before sending to drain. My question is, what is the easiest way to adjus
