Electronics Forum | Wed Mar 05 12:23:31 EST 2003 | msivigny
Hello Phil, We did use an Oracle relational database with an Access front end to input and query data from the system for reports. We did not perform SPC with the Oracle dB. As the whole data collection process was completely customized, we hadn't im
Electronics Forum | Wed Mar 05 10:10:27 EST 2003 | msivigny
Hello James, That sounds very interesting. I didn't know a system like this was available. What is a vision check machine? Is it a software monitoring tool that is installed on manufacturers equipment to evaluate the conditions you mentioned? I'd lik
Electronics Forum | caldon |
Wed Jun 04 13:19:57 EDT 2003
Electronics Forum | Wed Jun 11 09:59:19 EDT 2003 | jgregory
Hello all, We have came into this problem that I wanted to get everyone's input on from the SMTNET. We have roughly four pieces of equipment from a major manufacturer that we purchased from various brokers. We have two reflow ovens, one wave solder,
Electronics Forum | Wed Jun 18 10:07:02 EDT 2003 | caldon
There are a few directions to go from Here... 1) Outsource it to a CM, 2) Capital investment both have there issues. To Out source I would have processes in place to Inspect quality, resolve issues, Assure quaility, and Hope they can meet your deadli
Electronics Forum | Wed Aug 06 13:49:25 EDT 2003 | severs
Yes it is a conflict of interest. If the rep in > question is also calling on other contract > Assembly houses. If the rep is not calling on > other Ca's then I would say no. > Yes it is a conflict of interest. If the rep in > question is also
Electronics Forum | Fri Sep 12 00:19:37 EDT 2003 | Dean
In my humble opinion: 1. Use of computers and software to support cad programming and industrial automation. 15 years ago I was making programs with a pair of calipers and a swing arm digitizer. Now in a few hours an entire line (2 P&P machines,
Electronics Forum | Mon Oct 13 13:34:13 EDT 2003 | caldon
HI Andrea- to answer Q: 1) Stencils can be order through various vendors that manufacture stencils. You would need to have CAD data for the Stencil company to make them. You design engineer should have the CAD info. Also, the stencil design company c
Electronics Forum | Mon Nov 17 13:18:08 EST 2003 | SMTnet Admin
Several message have been deleted from this thread and it has been locked. Threads like this have the dubious distinction of making insider news for this community while, at the same time potentially vilifying corporate decisions to the point of sla
Electronics Forum | Fri Dec 12 01:06:02 EST 2003 | kenny
Dear folks; I am currently looking a PCB manufacturer who can fabricate PCB with the following specification:- Board sizes: _20000__ x _20000__ mils Thickness: 125 mils PCB material: FR4 Surface finish: 30 microinches Gold over 200 micro inches Nic
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400