Electronics Forum | Thu May 02 14:58:20 EDT 2013 | stephendo
Kurtz had a guy that was great with the machine. I strongly suggest that you watch the wave height test a few times in the morning then at lunch and at the end of the day. Look where the solder goes up to on the probe. If it doesn't work consistent
Electronics Forum | Tue Apr 30 10:03:31 EDT 2013 | mmjm_1099
Got it powered back on Friday.... We did check the UPS (power-supply)and indeed it was bad. So we referenced the manual and found you can bypass the UPS all together. So we just directly plugged the machine past the UPS. Well the machine is running b
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Sat May 18 10:21:09 EDT 2013 | davef
isd.jww: Comments are: * Current thinking has flux volatiles being the major contributor to voiding, not scavanging by via * I have no reason to think that 0.3mm via won't gladly accept solder. Plug them, if that's a concern. * If your concern is ina
Electronics Forum | Wed May 22 11:00:14 EDT 2013 | davef
Senor Tech: Roland and I talked about this situation in our weekly meeting and thought that it would be neat to add a feature to 'Equipment Wanted' that allowed the listing to be a blind Request For Quote [RFQ]. In this, the RFQ not show on the onlin
Electronics Forum | Thu May 23 13:17:29 EDT 2013 | zrunkle_api
After I write a new program the machine started doing what I would call a double board stop check on the board the first is like 12" from the front end of the machine and the other is in the middle where it should be. Only problem is once the first
Electronics Forum | Wed Jun 05 05:10:10 EDT 2013 | rollon65
Hi all. I already have a pair of Quad 4C Mk2 and purchased a Quad 4C Mk2 CE model secondhand. Some of the machine powers up but not the motor PCBs so the start up sequence stops after the nozzle changer operates with Motor Error #5 on the handheld.