Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Fri Mar 20 18:04:59 EDT 2009 | clearblue
We are having the same error message (F-Axis-23: X-Axis transducer ch.1 PTP value too low) on our TP9-2U that you had in 2007 with your TP9 2. I am hoping your memory is excellent, you are still at this email address, and you were able to fix the ma
Electronics Forum | Mon Jul 30 11:08:23 EDT 2007 | swag
I have a new contract with boards that have straight edges and are good for v-score breakout panel design. However, many of the traces are very close to the edge of the board so I am concerned that the traces could be damaged when we run them throug
Electronics Forum | Mon Jul 30 16:34:45 EDT 2007 | John S.
We're seeing shorting from the lead of an electrolytic cap to the can. It appears to be solder wicking up the lead, through the boot, and then shorting to the can. Has anyone else experienced this? It is a very cheap cap from China of course, but
Electronics Forum | Wed Aug 01 13:33:01 EDT 2007 | john_smith
We have Siemens Siplace Pro software for our Siemens equipment that allows you to overlay the solder layer against the placement data to verify placement,part rotation and part size are correct.Since we have been using this software we have not neede
Electronics Forum | Thu Aug 02 14:06:37 EDT 2007 | mattkehoe
Does anyone know of a company that can build a custom machine for someone? Somebody in the Atlanta area? We are going to be hiring a company to build a specialized machine for us and I thought I would put it out there in case someone does this kind
Electronics Forum | Thu Aug 02 14:27:28 EDT 2007 | slthomas
We're having problems figuring out how to optimize our stick feeders. We want to keep them all on the back side but the only way we've been able to get the data generator to finish optimizing without errors is to make all feeders movable, and it send
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
Electronics Forum | Fri Aug 03 02:18:41 EDT 2007 | cadcopac
Hi Steve, I agree with Darby on this your poor operator will be walking a mile a day!!! but if you absolutely want them on the back try this .... in your components listing set the feeder position for all your vib components to a number between 100
Electronics Forum | Mon Aug 06 11:46:35 EDT 2007 | slthomas
If we optimize with "feeders move" selected it just puts them on the front anyway, even if we've assigned rear feeder positions. I think you're right about wanting to default to the front unless it's out of positions. What I'll probably do is move t
.gif)
