Electronics Forum | Wed Feb 03 15:50:00 EST 2010 | boardhouse
jamboy, sounds like their have been some quality and personal changes since C-tec was purchased by DDI. I would look at having this board quoted at TTM in Chippewa falls,WI. I have no affiliation with TTM, other than I know that they are able to
Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
Electronics Forum | Thu May 06 13:06:36 EDT 2010 | dwonch
Unfortunately nothing ground breaking to report. The board shops analysis (SEM/EDS)showed high levels of carbon and oxygen, likely indicating an organic based contaminate. They are still stumped on where it is coming from. We recieved some boards y
Electronics Forum | Sun Apr 25 21:01:57 EDT 2010 | m79d
Hi all our IP1(1993)is not reading the board fiducials, the light comes on at the fid camera and stay on and the machine just hangs. Need to press the emergency stop button to go any further and screen says 'mark not readable'. None of the bulbs h
Electronics Forum | Fri Jun 18 15:37:44 EDT 2010 | remullis
One thing I have run into when placing cap's flush to the board is blow holes due to the plastic sheathing used around the cap. It would form a gasket going through wave and exhaust out of the holes therefore blowing the solder out with it. This cap
Electronics Forum | Thu Sep 30 16:28:51 EDT 2010 | 18424
Hello All, looking for some help from you guru's. I have several Enig boards with solderability problems. Components ranging from 0402's to ssop's. Using AIM W/S leaded solder paste, profile is beautiful and has been for years running the same produc
Electronics Forum | Mon Oct 04 10:02:09 EDT 2010 | babe7362000
I have a question about Drying a PCB after it goes thru the washer. Just wondering if others have to dry components off using air at the end of the wash? Our current process is that we wash the boards and dry certain parts off with the air hose aft
Electronics Forum | Sun Nov 14 14:14:47 EST 2010 | methos1979
On the bare boards, no paste, just a bare FAB board. We get them from a PWB manufacturer and inspect them to IPC-A-600 and then ship them to another manufacturer to populate them and we then inspect them to IPC-A-610. I have written several program
Electronics Forum | Wed May 25 17:56:24 EDT 2011 | rssimmons
The SimmScope is an first article inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator t
Electronics Forum | Sat Jan 08 07:28:19 EST 2011 | jeffr
David, If you have no floppy drive, then your machine is a pre 1990 or earlier machine. (Not CSM84VZ). These machines have a RAM memory with 14 programs max. Can you verify this for me with a picture of the inside of the front of the controler. (jr@h
