Electronics Forum | Fri Jul 09 12:18:03 EDT 2004 | Mark
This is a shot in the dark for you. On some of our low running boards (5 pieace). Instead of turning the wash on the operators will use a good ole steam cleaner. We used DI water in this process. The main reason we started using this in the first pla
Electronics Forum | Fri Jul 09 12:32:34 EDT 2004 | rtaft
It looks like our max batch size will be 50 boards (approx 5" x 3") and we will run 1 per day. I am researching the contract for references to using only RMA flux. I don't think there are any. It is starting to look like the OA with DI diswasher is
Electronics Forum | Fri Jul 09 13:17:40 EDT 2004 | Mike Konrad
The following link discusses the advantages and disadvantages of batch and inline cleaning equipment. The validity of each technology is determined by your unique / specific application. http://www.aqueoustech.com/Q_A_Batch_Inline.htm Batch mac
Electronics Forum | Sat Jul 10 18:19:16 EDT 2004 | Alfredo Diaz
Hello All, We are in the process of setting up a SMT line and would like you guys to recommend a company who help us to do the movement, set up and alignment of the machines. Machines are MPM UP2000, Fuji CP642, Fuji IPIII, Heller 1800EXL Oven. Tha
Electronics Forum | Tue Jul 13 00:40:44 EDT 2004 | Darren
Yes of course we are doing placement of BGA's with an IPII. However there is no front lighting so you can not inspect the balls. If the silhouette is square enough there is no problem with alignment. Just use the largest nozzle that will fit on the p
Electronics Forum | Mon Jul 12 17:32:53 EDT 2004 | Petros
Can anyone tell me if the Panasonic K-style green emboss 08x04 feeders can be used interchangably with the white paper ones? If so what is the importance of the push pin and are there settings in the machine that need to be changed? Also is this (whi
Electronics Forum | Thu Jul 15 13:41:23 EDT 2004 | Claude_Couture
We use paper tape in green emboss feeder without problems. But you can't use emboss tape in white paper feeder because the bottom of the tape needs a channel so the tape is supported on two side. Also, we remove all push pins. they are useless. We ne
Electronics Forum | Tue Jul 13 06:49:53 EDT 2004 | imtiaz
In one board we are using 213 SMT components out of which 23 components are lead-free and the rest are leaded. The paste used is also leaded. Do we have to make any changes in the profile of our reflow oven ? Also will there be any negative effect on
Electronics Forum | Wed Jul 14 00:50:34 EDT 2004 | Grant Petty
Hi, What's the best process for going lead free? Ordering lead free parts and using them with current paste, and then once all the parts are lead free, moving to lead free paste as well? Then the wave will be fun to change over. What a nightmare th
Electronics Forum | Tue Jul 13 14:47:35 EDT 2004 | cyber_wolf
I have a brand new X/Y/Theta table for an SPM(The one that uses magnetic supports) that I would like to trade for an older version table.(The one that has holes drilled and tapped in it.) the one I trade for has to be in good condition. No stripped h