Electronics Forum | Fri Jul 16 15:01:31 EDT 2004 | waveroom
I cant wait to hear the replies. We are an Ersascope dealer. Have sold over 25 systems. Have looked at all the competitors and Fortunately in our minds, Ersa still offers the best system. Not the least expensive, but the best. I found that ease of
Electronics Forum | Sat Jul 24 11:13:10 EDT 2004 | Steve
I would contact my local distributor. Using a Heat Gun is not the best method for rework. Using the Air Bath depending on board specifications also may not be the best method. Try a small distributor rather than a catalog house. Usually the small dis
Electronics Forum | Tue Jul 27 08:55:21 EDT 2004 | Cal
CJ- If I am not mistaken the Zephytronics machines have a money back guarantee if not satisfied. We have boards with huge ground planes and the air bath is the only rework that can do this. We also have found heat guns get hot enough but the heat is
Electronics Forum | Mon Aug 16 13:49:10 EDT 2004 | Paul
You are welcome. I typically just read here and try not to post, but the other post was unfairly negative and seemed to be biased to a single supplier...which I always find suspect. Here are the links to APE and ZEPHYRTRONICS which I hope you find h
Electronics Forum | Sun Jul 18 21:11:03 EDT 2004 | Thomas
Hi all, Need some advice on wavesolder pinholes issues. The PCBs are stored in a warehouse for 6 months and not vacuum packed. Before wavesodlering, boards are baked 2 hrs at 110 deg. But every piece of it has pinholes at random locations. PCB i
Electronics Forum | Sun Jul 18 21:15:05 EDT 2004 | Thomas
Hi all, Need some advice on wavesolder pinholes issues. The PCBs are stored in a warehouse for 6 months and not vacuum packed. Before wavesodlering, boards are baked 2 hrs at 110 deg. But every piece of it has pinholes at random locations. PCB i
Electronics Forum | Sat Jul 31 23:17:48 EDT 2004 | Bryan Sherh
Hi,Please 1.X-ray your board where you found pinholes.perhaps you'll found much voids in your joints,but not only the pinhole.this must be caused by the poor solderability of PCB mostly...or components. 2.Cross-section the pin hole or void in the joi
Electronics Forum | Fri Jul 23 05:25:20 EDT 2004 | greg york
Got to agree with John on this, get a stencil cleaning wipe something a little more potent than standard IPA and wipe the surface thoroughly, this should produce a green residue of solder resist. If this does happen then ask your PCB vendor to look a
Electronics Forum | Fri Jul 23 06:48:23 EDT 2004 | mattkehoe
I am actually getting opinions that point to contaminated copper under the HASL finish. We've seen some "fish eyes" where the HASL is pulled away from the copper exposing a pin hole of copper that can be seen through the HASL finsh. We are planning o
Electronics Forum | Sat Jul 24 04:02:18 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch