Electronics Forum | Thu Aug 24 08:49:20 EDT 2006 | nodlac
Hi Jerry- The belt splice kit we used were made by Eagle Belting Company (Now Fenner). You are correct in the splice process...one other thing we did was trim the extra "roll Back" or flash of melted material. I prefer the Mini or regular but splic
Electronics Forum | Fri Sep 22 12:21:06 EDT 2006 | daxman
We are using the Universal tooling..the one with the side plates. I'm not sure what the C-tool is. The machine did not come with much. I'm running the vision system test now..I've never done it before..but I'll let you know what happens with it. To
Electronics Forum | Mon Sep 25 12:50:42 EDT 2006 | chris g
Daxman, The diagnostic results didn't look very pretty. Especially on the vision x standard deviation. Any time there is an asterisk, that is a bad thing. The failure number for all axis, excetp theta, is .0002. Could need more air flow to the x
Electronics Forum | Tue Sep 26 09:57:19 EDT 2006 | daxman
Thanks Chris... I do not have the c-tool, but I did make some adjustments to the middle cube when I was calibrating it. Like I said in an earlier post, I cleared the vision offsets in the ap.cal file and adjusted the middle cube until the board alig
Electronics Forum | Fri Mar 09 17:49:08 EST 2007 | Frank
Thanks, Michael, this proves my point. There are already shows everywhere, so if you don't want to fly to LA and get "shot at", by all means, go to your local show. If enough people stop going to APEX (SoCal) then the other shows will gladly take u
Electronics Forum | Mon Feb 26 10:02:27 EST 2007 | Cal
Pay Recyclers: Ecological Technologies, Inc. 1230 Oakmead Parkway, #308 Sunnyvale, California 94085 U.S.A Phone: 408.524.7100 ;Fax: 408.524.7103 http://www.eco-tech.com/index.shtml OR The SemiCycle Foundation 2111 Kramer Lane Austin, Texas 78758
Electronics Forum | Wed Jul 07 11:02:07 EDT 2010 | davef
Rob gave you very good analysis and suggestions for troubleshooting your non-wetting issue. We agree with his sequence of troubleshooting. The following comments are meant to be a line to supplement Rob's plan of attack. This adds to Rob's comment
Electronics Forum | Wed Sep 07 00:47:53 EDT 2011 | woodsmt
PCB, What is telling you that you have cold solder? You do not give much info. My QA/QC love this term to describe a multiple of issues. They are usally very wrong. If this is a reflow process and it just affects one part? An SSOP is not likley t
Electronics Forum | Thu Jun 14 00:10:18 EDT 2012 | tech1
Most of it depends upon the type of Y wagon you have. if they are internal conveyors you need to remove the covers from the operator side. There are 3 screws holding the Y wagon down, 2 of them are hex screws and the one in front is an allen head. W
Electronics Forum | Thu Jan 16 22:59:04 EST 2014 | comatose
As far as OEMs go, Universal themselves are pretty reasonable about second-user support. Its only $500 to register an older GSM, and their factory field service people aren't any more expensive than many competent smaller companies. You do have to bu
