Electronics Forum | Thu Sep 02 11:45:47 EDT 2010 | kevm
We have tried solderability testing using an agressive flux and have had good results. However, our Mfg process uses laser soldering equipment which is a validated process and we are limited on the type and amount of flux we can use due to ionic cont
Electronics Forum | Fri Nov 05 03:53:29 EDT 2010 | Mark
The smallest particle sixe for type 3 paste in 25 microns. This is far to big to remain airborne.Therefore I would suggest to continue to use air to clean stencils as it does clean the apertures effectively.What solvent is used to clean the stencils?
Electronics Forum | Thu Dec 02 01:24:06 EST 2010 | jucki
Hi All If whoever has used before SMT SL2220 semi-auto printing, please let me know and discuess how to run it properly. I'm not so convenient to use it. Please share knowledge with me. Thanks
Electronics Forum | Fri Feb 25 03:00:20 EST 2011 | Jacki
Hi May I know what contratry between using and not using the air knife in wave soldering? Thanks in advance.
Electronics Forum | Thu Sep 29 07:14:41 EDT 2011 | williamaxler
I am trying to decide what type of no clean flux I should use in our selective solder machine. We run both leaded and lead free and would like to use the same flux for both. What is everyone else using? Or do you have any recommendations?
Electronics Forum | Tue Oct 11 09:21:33 EDT 2011 | davef
Can you use trichloroethylene to clean boards? Yes Should you use trichloroethylene to clean boards? NO!!! Don't use trike. It is an environmental and a personnel health hazard. What are you looking to clean from your boards?
Electronics Forum | Fri Jun 15 05:28:55 EDT 2012 | eniac
DeanM, if I understood correct, you use fiducial with dimension 0.1 mm and increased it to 0.15 mm. Why use use small fiducials? You don't have free space on your PCBs?
Electronics Forum | Wed Apr 03 03:41:00 EDT 2013 | ericrr
We used to use Butyl-glycol then I ran out and someone said it was no longer available. or maybe it was cheaper without it. After you use that you clean off the Butyl-glycol with IPA (Isopropyl alcohol)
Electronics Forum | Mon Jul 29 18:26:57 EDT 2013 | sfeinsp
We using nitrogen only for Selective Solder machine, you don't need it for reflow oven, to improve solderability we use Vapor Fase oven.
Electronics Forum | Fri Jun 05 05:54:07 EDT 2015 | JB
What we have found after using the machine for a while is that its difficult to set up most odd / uneven parts. The best way we have found is use the trimmer package and then use the rough check feature, that seems to work well with most things.