Electronics Forum | Tue Mar 15 10:34:19 EST 2005 | Patrick
Jimk: My company is a major global manufacturer and supplier of liquid nitrogen. We also provide technical support for electronics applications and aid users in equipping/retrofitting their soldering equipment for nitrogen use. What general state/pr
Electronics Forum | Fri Mar 11 09:42:50 EST 2005 | cyber_wolf
If you are not getting repeatable transducer readings then some possiblities are : 1. Transducer is bad 2. Motor is bad 3. Y power booster Also, I can't remember if the Y motor has a flex coupling on it or not. If it does, check that out. Also, w
Electronics Forum | Fri Mar 11 11:19:02 EST 2005 | Steve C.
I would change the Quad Align cable. If you have a spare head board swap that out as well. Make sure your Quad Align lenses are clean. If the camera is smudged then you can have some problems aligning parts as well. Let us know what you find. Cheers.
Electronics Forum | Fri Mar 11 14:04:34 EST 2005 | Micheal
I changed both cables and still the same thing. I have not changed the quad align cable yet. Any other ideas. Also when I do a run pickup 1 it works normal but when I am in run mode forget it, the z-rod now dont even go all the way down.
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
Electronics Forum | Mon Mar 14 10:38:02 EST 2005 | ???
Are you absolutely sure that you changed the x-y ribbon cables....the z is controlled through those cables and almost all the time one of the cables has an intermittent open. I think there is a small card in the top of the machine (under the black co
Electronics Forum | Sat Mar 12 23:50:47 EST 2005 | fastek
Marcus- I guess I'm too old school. When I was involved in manufacturing there wasn't any AOI and we got along fine for years without it, (like everyone else). But I can certainly see the benefits of it if you have highly complex boards that are jus
Electronics Forum | Fri Mar 11 10:47:24 EST 2005 | thaqalain
(1)While fixing feeders to reels ,some small componets are displaced or fell down out of reel and there will be discontinuty.In-fact there will be probability of this till we load magazines to machine. Is there any effect, I mean ultimately,will we g
Electronics Forum | Fri Mar 11 11:10:59 EST 2005 | AshleyN
We are currently masking and dipping. I need to source a selective conformal coating machine. I'm looking for something that's easy to program, accurate, good running costs and all that good stuff, semi-automatic, and repeatable for operators to use
Electronics Forum | Mon Mar 21 08:46:05 EST 2005 | GS
Hello Gents, Many thanks Davef for your always helpful informations. I have a question, pls, related to : which kind of Test Method are they going to be used to perform analysis (Rohs Compliance verification tests) on EEE in order to find out oncen
.gif)
