Electronics Forum | Mon Jun 19 09:57:44 EDT 2017 | tnisbet
https://www.youtube.com/watch?v=wbQK3-JwUNQ
Electronics Forum | Mon Jun 19 11:53:22 EDT 2017 | westshoredesign
Out of curiosity, are these compatible with all C series models?
Electronics Forum | Mon Jun 19 09:53:27 EDT 2017 | tnisbet
Hi, Yes you can add a paste dispenser to the Quad 4C. The system will dispense DOTS and DOT patterns, no lines. We sell kits to add the dispenser. It takes about 4hours to install the kit. We also sell Camalot dispensers, benchtop & floor models. w
Electronics Forum | Tue Jun 27 08:53:43 EDT 2017 | westshoredesign
PPM, like mentioned above. You'll find they have most, if not all parts you'll ever need. http://ppmparts.com/spares/pickplace/quad/
Electronics Forum | Mon Jun 19 21:17:41 EDT 2017 | arachid
https://www.youtube.com/watch?v=wbQK3-JwUNQ > https://www.youtube.com/watch?v=wbQK3-JwUNQ Hi, where can i get price and where i can buy the kit.6 Thanks
Electronics Forum | Fri Jun 23 13:02:45 EDT 2017 | arachid
Hi, where can i get price and where i can buy the kit?Thanks
Electronics Forum | Mon Jun 19 08:49:40 EDT 2017 | westshoredesign
Just buy a separate machine to apply paste. You'll be able to run faster, (by doing more at the same time) and you can probably find an air-over-syringe system for less than $2000USD. At the end of the day, that's probably less than you'll spend in t
Electronics Forum | Fri Dec 03 20:40:38 EST 2010 | olddog
We are a small company looking to purchase a used Quad 4c to bring some of our PCB fab in-house. In looking around at equipment we see both 4c and 4c mk2 versions of the Quad machine. Can someone please advise the difference between the two? Thank yo
Electronics Forum | Mon Dec 06 11:33:30 EST 2010 | gantry
It has been a while but I think the Mk2 was an upgraded ballscrew. I am a fan of the Quad products but if you are looking to bring production in house using these machines to do it, I would be very very careful and really consider new machines with
Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,