Electronics Forum | Thu May 26 09:47:13 EDT 2005 | Dave G
We use the 3748. We picked it many moons ago after doing product HALT & HASS testing. Basically the run of the mill hotmelts didn't hold up as well under the conditions our equipment lives in. (We do a lot of MIL,Aero & Industrial motor/actuator driv
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Tue Aug 03 11:40:41 EDT 2010 | swag
HSP nozzles get pushed back up into the head by a cam with a pneumatic brake on it. Make sure this is functioning properly. It is not uncommon for the MAC valve that actuates the brake to get flaky = replace it. Also, the nozzles are mechanically
Electronics Forum | Wed Mar 01 07:48:33 EST 2017 | coryhayes89
I have an older Flexlink F1700 that I am having issues with and am hoping someone might have a fix for it. The issue is that the machine will initialize when you turn it on, meaning the belts will spin. However, it never returns to its 'home' posit
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Mon Aug 06 14:24:12 EDT 2018 | dleeper
I had a similar problem once on an acculfex. The root cause was a short on the one the wire harnesses connected to the print head. If I recall, most of the relays in an accuflex are actuated by the 24 volt bus, so if you have a short anywhere in tha
Electronics Forum | Wed Apr 28 15:18:17 EDT 2021 | dilogic
24V feeders are very simple to interface. You have supply voltages (24VAC, 12VDC), status output and control input (advance). All signals are using 12V levels. To advance feeder pull control input to GND. Connect status output to +12V with a pull-up
Electronics Forum | Fri Mar 04 04:44:16 EST 2005 | ianlg
Hi I do not expect that anyone will provide you with schematic s for the board itself as providing detailed info on the boards was regarded as a no no when I was working for SMTech/Speedline SMTech. We do not ourselves have detailed schematics but
Electronics Forum | Mon Dec 05 09:04:25 EST 2011 | haiae
I just buy a used Contact 3AV machine. Afer fixed some things I think the machine can be ready to run and in fact for first time the machine power up, pass all self testing, homing is done, moving of table, heads, actuator is good, pneumatic function
Electronics Forum | Fri Oct 29 12:18:45 EDT 1999 | stefano bolleri
We have also placed BGAs with IP-2, with no problems. Ours were 50 mil pitch PBGAs, and as Doug says the perimeter is more than enough to place the part. We have only placed from matrix tray so far. The ONLY problem is the center array, for parts tha
