Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Mon May 03 20:17:40 EDT 2004 | Jacek
Try to check axis drivers - at the begining should be tactile. When you press RESET look on the screen - is there any change (position send from encoders) ?
Electronics Forum | Mon Feb 06 06:35:28 EST 2006 | dougs
Sr Tech could be right about the C-AXIS coupling, i've seen that happen before as well, although the noise happened when the cam was sitting still at 0deg, not when it was turning, the noise was from the motor hunting for position.
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Mon Sep 21 12:15:55 EDT 2009 | swag
Can anyone tell me the correct DIP settings and jumper positions for a MpM AP25HiE Z-axis driver card? Thanks-
Electronics Forum | Wed Dec 19 12:31:14 EST 2012 | emeto
1. Check for pins or something else under the rails. 2. Check the motor for the axis and the sensor that defines up position(I doubt it there is an encoder for this motor) 3. check card 4. check interface cable
Electronics Forum | Thu Aug 14 13:49:26 EDT 2014 | dyoungquist
Motor control MSETDYN -> Initiate axis C -> Centering jaws 156 -> Motor timeout Did not reach specified position Hardware problem Looks like you have something wrong with the movement of your centering jaws.
Electronics Forum | Mon Feb 25 11:35:40 EST 2019 | dekhead
Does camera complete moves (Baord stop, Fiducial Positions) without error in camera diagnostic?
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
.gif)
winsouce.jpg)