Electronics Forum | Tue Mar 14 05:02:35 EST 2000 | emmanuel
I am to implement PBGA, and i am looking for PCB surface finish informations. A lot of technical reports are specifing NiAu finishing because of flatness property. Because of leads shape, I though that BGA doesn't need flat pads like QFP. Is it false
Electronics Forum | Mon Jun 26 08:54:35 EDT 2006 | dougs
We have a new product in where a 0.7mm pitch uBGA is to be placed on a 2 layer flexi board. Also a 20thou pitch connector. Has anyone done anything like this before, what should i look out for. Not done much flexi work before so any tips will be g
Electronics Forum | Tue Jul 11 10:13:22 EDT 2006 | SWAG
Over time, you might see problems with delam., blistering and warpage if using FR4 carriers. Depending on volumes, you might consider using durostone or some robust material like that for the production runs. Keep in mind that switching materials w
Electronics Forum | Sat Jul 29 09:10:16 EDT 2006 | davef
Ball Grid Array (BGA). A surface mount technology leadless package with the connectors to the board placed in an array on the bottom of the package. They are attached to the board with tiny balls of solder placed on each contact. Pin Grid Array (P
Electronics Forum | Tue May 26 14:39:40 EDT 2009 | boloxis
QFN or MLFs are mainstream now, QFNs already evloved to much more complex versions now like matrix pins, stacked dice and flipchip versions. IPC 610D already includes them, just make sure the pins have solder plating, the PWB pads have soldermask in
Electronics Forum | Tue May 18 16:40:22 EDT 2010 | m79d
I am having some problems getting the IP1 to place a SSOP28 package,pitch 0.65mm lead width 0.3mm. I am selecting computer vision 012 (tried 011) and vision type 100. EL data was put in looking at the datasheet and also measuring the device. Have tri
Electronics Forum | Sun Mar 01 15:52:13 EST 1998 | Earl Moon
| From several months I am investigation about the VOIDS PERSENCE and his important as reliability. | One question now is : | It is possible that on the BGA components the voids are already present into the balls, before the mounting on the pcb ? | I
Electronics Forum | Thu Mar 13 01:42:58 EDT 2008 | Sean
Thanks Real Chunks and Davef...Yours input is valuable to me. My inputs towards your question asked below: Questions are: * Why did you tell us the following? "This BGA is installed with heatsink (with hook at both side of the heat sink) manually b
Electronics Forum | Tue May 28 13:46:27 EDT 2002 | Yannick
Hi, I know that this topic have been discuss before but I would like to know what kind of equipement do you use to check your BGA and to rework it? What should I look for before buying something. Some people said that is not a good thing to
Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq
Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the