Electronics Forum | Wed Jul 14 14:05:52 EDT 1999 | KT
| I need some advice concerning reflow of a BGA-292. Since I am not ready to change my entire process to no-clean, I decided to place the lone BGA-292 on a proto run using our BGA re-work station. The pcb is a moderately dense, single-sided, 8-laye
Electronics Forum | Mon Jul 12 12:28:10 EDT 1999 | Wolfgang Busko
| I need some advice concerning reflow of a BGA-292. Since I am not ready to change my entire process to no-clean, I decided to place the lone BGA-292 on a proto run using our BGA re-work station. The pcb is a moderately dense, single-sided, 8-laye
Electronics Forum | Sun Jan 14 12:42:35 EST 2007 | SMTRework
I think the main cause of this condition is #3 because both #1 and #2 never change from board to board, these are identical boards with identical BGA revisions. These BGA's (as stated before) are about 3 years old.. I don't believe they are lead free
Electronics Forum | Mon Jul 12 10:21:06 EDT 1999 | Earl Moon
| I need some advice concerning reflow of a BGA-292. Since I am not ready to change my entire process to no-clean, I decided to place the lone BGA-292 on a proto run using our BGA re-work station. The pcb is a moderately dense, single-sided, 8-laye
Electronics Forum | Wed Jan 05 11:01:37 EST 2000 | Ron Lahat
I have in design a 400mm x 400mm pcb 3.0 mm thick heavily populated with BGAs 50 mil pitch and want to run a double sided reflow process with overlapping BGAs (CS/PS) 1. can I avoid a selective jig for PS BGAs?(weight calculation ?) 2. Is it possibl
Electronics Forum | Wed Jan 04 13:59:14 EST 2006 | chunks
Ask your customer why they need this? Show them your process. Then bury them in their own unknowledgeable requests. It is pretty scary how many papers are also written about how easy it is to reflow a lead-free BGA with regular leaded paste. ht
Electronics Forum | Wed Nov 01 13:44:50 EST 2000 | Thomas Ballhausen
Using convection type reflow we observed following problem: One ball of a 313-PBGA appears to be dewetting. This happens randomly, i.e. no specific ball location, failure rate is rather low (3-4%), but since there are 12 PBGAs on one board the failu
Electronics Forum | Thu Jan 11 09:19:56 EST 2007 | SMTRework
I know this is not the correct forum to post chip "reworking" questions but you guys have been very helpful in the past. My question is this, when we rework BGA components most of the time the solder reflows at a normal temp and all is well. On occ
Electronics Forum | Sun Jan 14 12:48:53 EST 2007 | SMTRework
Also, I was beginning to think that the humidity level in the facility was a factor.. but I don't believe that's the case.. as this condition seems to occur regardless of the humidity level.. Equipment being used is as follows.. Metcal BGA 3500
Electronics Forum | Wed Jun 29 16:25:51 EDT 2005 | mattkehoe
When discussing this with the customer he said that his vendor recommended a hard gold plating finish on the board due to the BGA. I said "hard gold"??? And he said yes, hard gold. Turns out the boards were plated with hard gold, not ENIG. Thank
.gif)
