Electronics Forum | Thu Nov 05 17:39:21 EST 1998 | Dave F
| Is there anyone who can help me with the average profile to start and speed of the above-mentionned oven ? Have you used the blower at any other setting than 100% use? | Barbe: The first pass at setting your profile should be based on: 1 Sol
Electronics Forum | Mon Aug 25 12:43:35 EDT 2014 | freddimock
Numerous people use the Pyramax oven to process high temp solder but your success will depend upon the mass of your board. To maximize the probability of success you should use the highest convection rate (IWC) possible to enhance heat transfer an
Electronics Forum | Mon May 24 16:45:44 EDT 2004 | Bob
BTU as well as most oven manufactuers have great products. If they fit what your looking for and can give you good support(preferably local) then you should not really see any quality problems with their products. With the oven max temperature of 300
Electronics Forum | Thu Jan 27 20:36:13 EST 2000 | Dave F
HJ: Your best chance of running your boards with a single profile is with ovens from the established suppliers (ie, BTU, Conceptronics, Heller, Vitronics, etc). They are experienced in robust control system designs. Stepping aside from that, consi
Electronics Forum | Thu Nov 05 14:00:54 EST 1998 | Barbe Alain
Is there anyone who can help me with the average profile to start and speed of the above-mentionned oven ? Have you used the blower at any other setting than 100% use?
Electronics Forum | Thu May 26 21:07:22 EDT 2005 | KEN
This is caused by cte mis-match. The balls in the corners are short and fat. The balls near the null point are tall and more normalized. I don't remember what the zone settings were... BTU VIP98 BS was probably 22-25 IPM
Electronics Forum | Wed May 24 10:40:22 EDT 2006 | dougs
Do you really need to have that shape of profile, why not have a gradual ramp then spike? Which paste are you using?
Electronics Forum | Mon Feb 14 16:32:13 EST 2011 | kmadison
Looking for someone with a background in Furnace Sales i.e. a retired BTU, SierraTherm, RTC, WJ, you name it sales person. Part time - full time Must be able to cross reference all makes for best fit with customers profile requirements.
Electronics Forum | Sun Apr 23 09:04:36 EDT 2006 | kanna
Does anyone have any experience with these ovens > ? We are looking at purchasing a used > one. Anything in particular I should look at > when inspecting it ? > > Any comments good or bad > appreciated..... > > Thnx, Sr. i have one problem he
Electronics Forum | Fri Nov 03 13:48:39 EST 2006 | monty
I have a BTU Reflow 8 stage (PCDIU software) oven. The max temp. that it will allow is 270 degrees. I am trying to use a High Temp solder paste and the profile states that I must go between 260 and 270 degrees. My question is, is there a way to incre
