Electronics Forum | Thu Apr 18 15:33:37 EDT 2013 | empac
Hello, Does anyone know how to fix the following problem on a DEK265GSX? Motor comms failure card1 AX123 Fatal error re-initialize machine. Appreciate your help! Bob
Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
Electronics Forum | Mon Oct 11 17:02:06 EDT 2004 | M Deren
We have a DEK 260 with a intermittant table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving hapazardly in small increments back and forth or vibrates as if it wants to mov
Electronics Forum | Thu Aug 23 09:44:09 EDT 2018 | midware
Hi. Please help. On DEK 265 GSX i've got on the monitor message: "DEK 265 GSX Motor comms failure, card 1, axis 123 fatal error." F1-F8 doesn't work, machine cant start. No result after Reinitialise machine. Which one is this card1? Is it in PC?
Electronics Forum | Mon Jul 03 03:42:32 EDT 2006 | teera
hello, pls check below item for paper stucks: 1)paper rolls diameter not over 60MM(new roll) 2)tension for roller clutch(silver u.s.c only) 3)make sure the under screen cleaner ROUGH ROLLER is clean and free for solder paste.so that it can turn smoot
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Wed Dec 07 14:20:29 EST 2005 | Robert
I had a DEK 265LT with error code: motor comms failure.card 1, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 1 and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, Rober
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Wed Oct 30 13:30:54 EDT 2019 | tnachamp
The consumables monitoring option totally disappeared from one of our printers. It used to show the level of paste, paper and solvent and now that window is totally black. I was wondering how we could get that option back onto the monitor. Thanks in
winsouce.jpg)
