Electronics Forum | Fri Sep 10 12:09:02 EDT 1999 | Earl Moon
| | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the pr
Electronics Forum | Sun Sep 12 08:20:04 EDT 1999 | se
| | | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the
Electronics Forum | Fri Feb 17 22:48:47 EST 2006 | bvdb
Thanks Jerry - I'll try it on Monday. Cheers, Bert
Electronics Forum | Thu Mar 22 17:24:19 EDT 2007 | coop
Have you tried changing the algorithym type in mark info. to special 1 or 2 ? you will have to perform an F6 on this after you change it. If you were on Normal before then you will want to lower the threshold from the what you have it set at ,probabl
Electronics Forum | Fri Feb 17 15:06:46 EST 2006 | jdengler
Bert, After pressing F1 for auto operations but before pressing start, press F4 SQ.N. This will ask for a sequence number. Press 1 on the number pad then CR. This will start the program a sequence #1. Then press start and all is well. Jerry
Electronics Forum | Fri Feb 17 12:53:30 EST 2006 | bvdb
We just got our used Fuji IP-1 working well. Sometimes during testing of a new program/pcb we like to stop the run and re-start with a clean board. When we make the IP-1 eject the unfinished pcb and start with a new pcb the IP-1 does not scan the f
Electronics Forum | Mon May 14 23:41:04 EDT 2018 | leandroxp
Hi. how to create a fiducial cross type in the SONY model SI-P750? Or would you need to upgrade your device software? Because my equipment only makes fiducial markings of circle and square type.
Electronics Forum | Wed Jul 16 19:38:28 EDT 2014 | garym4569
What is the base cost of an inline pcb etcher? Specs: fiducial alignment, smema interface, 400mm x 400mm marking area. Will be used to mark panel 2d codes, pcb array 2d codes, and human readable. Thanks Gm
Electronics Forum | Thu May 27 19:00:37 EDT 2010 | emrtech
not just speed, looking to reduce down time on having to re-do boards from bad stencil screening. also, the accuracy of placing solder paste down on PCB's. why would you want an employee spending so much time aligning fiducial marks from panel to pan
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u