Industry News | 2003-07-31 09:03:47.0
Tecnomatix Underscores Position as MPM Leader by Incorporating Widely Used Factory Floor and Execution Systems Software, Strengthening Reach Across All Areas of Manufacturing
Industry News | 2010-05-05 23:20:11.0
Niedernhall – PCB specialist Würth Elektronik once again demonstrates its competence in system solutions and customer support; now offering one-stop flex-rigid PCB solutions with ZIF contacts and custom designed ZIF connectors.
New Equipment | Industrial Automation
Contact: Nancy Lin Email:info@amikon.cn Skype:onlywnn_1 Telegram:+8618020776786 Mobile(Whatsapp): (+86)-18020776786 QQ :2851195456 Control Systems (DCS, PLC/SPS, CNC) - Panel Controllers - HMI and Display Panels - Industrial PC’s - Dri
Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
Electronics Forum | Wed Dec 07 20:51:59 EST 2022 | proy
cut time was very good (not a concern) Main advantage is flexibility and simpler fixturing than routing as there are no side forces. Charing was evident, but can be reduced with a few tweaks.
Electronics Forum | Thu Aug 31 04:25:03 EDT 2000 | Chris May
Dougie, If you have square, rectangular etc; shaped PCB's maybe you could have routing between circuits. "V" shaped grooves top and bottom. I found this extremely good especially if the assemblies are wave soldered. No gaps for flowing up and over.
Electronics Forum | Fri Aug 03 12:13:59 EDT 2001 | hinerman
T.A. board lok is fixed tooling. I have not used it, and therefore cannot comment on it. Their website describes it in detail for those interested. -The Grid-Lok system is completely pnuematic -Each pin locks individually via mechanical lock -Each
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Thu Jan 20 08:08:24 EST 2011 | deanm
Because we build Class 3 assemblies, our company has formal inspection steps on our routes. CCA's go through surface mount and then an operator inspects the solder joints for defects and corrects them (touch-up). Following this they go to formal insp
Electronics Forum | Fri Jul 16 14:05:04 EDT 1999 | Jim Blankenhorn
| | | Hi all , | | | | | | We are trying to implement the micro-BGA technology at our plant. I need the clarification to the following points: | | | | | | 1. Is underfill required for micro-BGAs? | | | | | | 2. What type of stencil apertures are t