Electronics Forum | Wed Jun 27 09:15:21 EDT 2007 | gregf912
The program that I use is the Fuji calibration program and it works fine on all other equipment that I use it on. The PDs are dialed in at 10% tolerance and the nozzles are new. I see it more on 105 and 1608 parts but it happens on 2012 and 3216 part
Electronics Forum | Fri Jul 19 11:02:15 EDT 2019 | dman97
You never answered my question on the proper data. Do you have a hard copy of the proper data? Is the diskette (if you have it) in Fuji Flexa format? In order for flexa to communicate with the CP6, you must have the correct proper data.
Electronics Forum | Thu Dec 28 08:10:13 EST 2023 | vickey
Always follow the manufacturer's guidelines and recommendations when troubleshooting or performing maintenance on the equipment. If you're unsure about any step, it's advisable to seek assistance from Fuji's technical support or a qualified service t
Electronics Forum | Mon Nov 24 17:27:39 EST 2003 | rrr
typically when i've seen this problem it is because the back of the mylar is sticky. Have you tried different parts?
Electronics Forum | Mon Nov 24 19:21:04 EST 2003 | alwil
Hi, I have seen this problem. Make sure that the peeler tape goes round all three pulleys as in the diagram on the feeder. Make sure the feeder clutch is oil free and not slipping. If everything is set correctly then it may be a component vendor i
Electronics Forum | Tue Nov 25 10:40:42 EST 2003 | Fuji_Dude
Try putting on new springs on the feeders. This a common and frustrating problem with CP6/7 feeders.
Electronics Forum | Tue Nov 25 10:40:50 EST 2003 | Fuji_Dude
Try putting on new springs on the feeders. This a common and frustrating problem with CP6/7 feeders.
Electronics Forum | Tue Dec 02 16:31:05 EST 2003 | ryanm
We have had the same problem for years. The way we have fixed this is by NOT winding the cover tape the way the diagram shows. We only use the roller that is connected to the index arm. Hope this works for you.
Electronics Forum | Mon Aug 22 09:34:54 EDT 2005 | Lee
i need documentation on off-line progrmming for fuji cp-642e can any1 help me?
Electronics Forum | Wed Jun 27 08:33:27 EDT 2007 | pekantol
Have you measured the preQ rotation station(st3).Is it workin correctly?