Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Tue Apr 04 23:01:37 EDT 2000 | Dean
Does Fuji America have a trade in program? I know they used to on vision cards and such. It may be worth your while to get a trade in allowance rather than none at all. The alternative, as you mentioned, is to repair it yourself. This however, w
Electronics Forum | Wed Jan 11 10:39:28 EST 2017 | davef
From “Nick's Software Blog” [http://nicks-software.com/wordpress/tag/list-of-abbreviations/ ] a very cool list of abbreviations … * SCU, Servo control unit or Sub-controller unit (on Fuji machines). * PMC, Placing module controller (on Q.P. Fuji ma
Electronics Forum | Tue Feb 14 06:43:15 EST 2023 | vasu278
Hello guys Iam upgrading my assembly line and i have all the spares of fuji CP-43 which include servos and motors any one intersted please contact me at email- vasuprasad20@yahoo.com
Electronics Forum | Thu Mar 21 05:39:08 EDT 2024 | acouto
Hello everyone, after several attempts it was necessary to change the servo box for a new one. It was fuji's solution.
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Tue May 24 05:21:32 EDT 2005 | Zsolt
did you try it with different product/programs? if not, then please try. It could be a mistyped placing position also. Is there any error code? Could be several reasons but I think servo amplifier or servo motor could be the cause. More info would be
.gif)
