Electronics Forum | Tue Feb 12 10:51:46 EST 2002 | stefwitt
Dave is right. There is no machine on the market which can handle a 1.5 m long "board". If you or someone else will have to tinker with a custom made machine, it will be less expensive to use a used machine ( I could be offering some used Siemens mac
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Wed Feb 13 13:32:15 EST 2002 | caldon
Liquid Control Corp May be able to intergrate a unit like you speak of. Contact Geoffrey Silver at : 215-918-0872 or silver@liquidcontrol.com. Best regards, Cal
Electronics Forum | Thu Oct 23 00:43:30 EDT 2008 | stanyserrao
Light Units are replaced with new if the problem of lights then it will not vision process the nozzle center measrement and resolution Jigs too.. Jig is meauring in trace mode and identifiying all leads which are fine fitch. But a 1206 resistor is
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Tue Feb 12 05:47:29 EST 2002 | Roy Barton
To Dave F. Thanks for your comments. I should point out that I am not well versed in SMT, I am more of a thick film and chip man. However I will look into your leads. I will try and find out more about the Quad equipment. I am very wary in getting
Electronics Forum | Fri May 23 04:25:14 EDT 2008 | muarty
One thing that has to be considered when using rheometric pumps is that the board support should match as that of the pump head being used. You can print 6" boards, but you should really still use board supports upto 16". As mentioned previously if t
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Electronics Forum | Thu Dec 15 12:45:15 EST 2016 | emeto
llllGodly, I did try before, but it wouldn't pick it - it will automatically select a tool for the single head. Do you think it has something to do with the fact that IO used ODD SHAPE recognition?
Electronics Forum | Sat Dec 17 02:37:21 EST 2005 | manyhats
Hi, it seems like you have some experience with the SM320... How do you feel about the reliability, and consistency of it? does it generate alot of error on a run? and what do you mean about feeders breaking the head? Also you're telling me that this
