Electronics Forum | Wed Feb 13 20:15:36 EST 2019 | aldrich17
They all rotate on the same belt but, 2 per head on heads 2, 4, 6, and 8. Placed on the front and back. Held by a bracket with 2 screws. But no matter how tight I set the screws upon adjustment they still get out of whack.
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Mon Aug 22 08:54:15 EDT 2016 | bobpan
More than likely the encoder scale or read head has an issue. Many times.. oil/dirt/water get on the scale and cause a bad spot or bad area. Try to clean the scale with a lint free cloth and alcohol. You should also be able to see the read head and m
Electronics Forum | Sun Oct 02 10:42:07 EDT 2022 | omar08
The Head H01 have this issue
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Mon Jun 12 11:04:20 EDT 2017 | bobpan
So what your telling me is kind of vague. Does the machine home and go to the front left corner of the machine? If it does....this could be a quad align problem....meaning dirt on the lens or so-forth. You should watch the heads homing in the z-axi
Electronics Forum | Wed Feb 13 16:27:28 EST 2019 | aldrich17
R axis is the rotation of the heads. 180 degrees and -180. The sensors tell the machine when the heads are switched correctly on the flying nozzles and the correct rotation. also i think they involve the clutch as well. After i make an adjustment to
Electronics Forum | Fri May 10 01:42:13 EDT 2019 | vinitverma
A Table is something that you can ignore right now. It is significant only in case of dual table machines such as Sapphire or Sapphire-X which have A and B tables (two independent PCBs being handled at the same time). In case of Topaz or Topaz X or E
Electronics Forum | Thu Nov 15 19:56:18 EST 2012 | rgduval
I would have said it sounded like a motor/encoder problem...but, since you found the broken resistor, that was likely the source of your issue. The resistor and capacitor are a filter for the motor, MyData likes to put them on nearly all of the moto