Electronics Forum | Mon Mar 29 14:58:08 EST 2004 | davef
Josh: Final cure of the LPI solder mask: 310*F for 45 minutes. Your board fabricator needs to do a better job. Most fabs do not check cure, because the processes subsequent to cure are so brutal that the fab expects the following process to highlig
Electronics Forum | Wed Aug 27 17:12:34 EDT 2008 | mikesewell
Silicone contamination could appear as fisheyes or dark spots under UV light. 1A33 can be heat cured but is a single component oxygen cure coating - it needs a source of oxygen to cure. An unvented oven may slow or limit the cure. Check out the TDS
Electronics Forum | Mon Jan 29 11:52:55 EST 2001 | blnorman
We have been using a VOC-free, no-clean flux on our boards that we conformally coat with no problems. We're using both a UV cured and a heat cured Silicone conformal coating. One thing to beware of is inhibition in the silicone. We found that out t
Electronics Forum | Mon Aug 21 19:38:33 EDT 2000 | Dave F
Eric: I�ll pass on the uV and ammonia, also. Thoughts are: 1 You�re correct that the temperature/humidity mix can be a big driver to latex peelable solder mask cure time, but don�t overlook material thickness. Dispensers put material in a very th
Electronics Forum | Tue Apr 18 12:34:15 EDT 2006 | Chunks
Outside the box: Can you retro your oven with a belt chain combo? I always order my ovens this way just in case. No pallet or carrier needed then. Can justify retro against the cost of the pallet or carrier. Two part epoxy instead of heat cure?
Electronics Forum | Tue Oct 17 01:12:50 EDT 2000 | Darby
Try "Amicon D125 F". Good for both dispensing and screen printing. I like the yellow colour, it shows up better on green pcbs. Most smd adhesives are single part, heat cured epoxies, UV curing having gone out of fashion some years ago. Amicon used to
Electronics Forum | Mon Jun 22 13:56:17 EDT 1998 | Upinder Singh
hi all. I am looking for a oven which can cure the conformal coating providing heat and the humid atmosphere. I am looking for a temperature range of 60 deg C to 80 deg C and a humidity range of around 80%. Can anybody refer to me the right vendors
Electronics Forum | Mon Jun 25 12:23:15 EDT 2007 | davef
Once the HumiSeal conformal coating has been applied to the printed circuit board it is usually best to allow the material to reach a touch-dry stage, before heating the board to accelerate the cure schedule. This avoids potential problems such as bu
Electronics Forum | Mon Dec 22 14:15:41 EST 2008 | ck_the_flip
As Emil says, it's 100% the glue! Your paste is not designed to hold parts on at wave solder. Reflow is MUCH hotter than glue, so I doubt you're not adequately heat-curing it. Possibly, the glue cure is "too hot" and maybe making the material brit
Electronics Forum | Wed Oct 17 02:04:39 EDT 2018 | robl
SCC3 has an operating temperature of 200C, as long as it is heat cured at 100C. https://www.electrolube.com/pdf/tds/044/DCA.pdf It's also a silicone so needs to be coated & cured away from anything you value. Otherwise there are plenty of PU's and
winsouce.jpg)