Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Tue Jan 11 11:38:25 EST 2022 | spoiltforchoice
Tool box with a marked home for every tool and adaptor, if its not in use its in its home, anyone caught with it on their desk because "I was using it yesterday" gets a slap. Some would call that LEAN methodology I believe.
Electronics Forum | Fri Aug 11 13:38:52 EDT 2023 | lauri
We have a Contact 3AV pick and place and we can't get the table to home. Any solutions?
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Thu May 24 16:09:06 EDT 2007 | ck_the_flip
So Stephen, I don't know what part of the country you're from, but during summer time, what DO you do with your air conditioning at home? "Your wrong" is a very general statement, without a "right" statement to counterpoint my wrong statement. Hon
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Wed Mar 01 07:48:33 EST 2017 | coryhayes89
I have an older Flexlink F1700 that I am having issues with and am hoping someone might have a fix for it. The issue is that the machine will initialize when you turn it on, meaning the belts will spin. However, it never returns to its 'home' posit
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Wed May 10 23:12:13 EDT 2000 | HussMan
OK, Im readn' this crap fom home. Nuff said.
.gif)
.gif)
