Electronics Forum | Mon Jan 10 13:31:32 EST 2005 | cyber_wolf
If you have a broken motor, try these guys. I have had them repair motors in the past. They are fast. http://www.servorepair.com/
Electronics Forum | Thu Sep 15 16:02:20 EDT 2005 | jdengler
Over Current means the motor is drawling too much current. Check for a jam on that axis, bad wire, bad motor, bad servo amp (yes the amp can go bad and make it appear that the motor is drawling too much current). Jerry
Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls
hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best
Electronics Forum | Fri Feb 15 15:09:24 EST 2008 | soudomphong
Anybody have any idea where to get the cutter motor for siplace 80-S20 with reasonable price? I am also looking for S20 head board, and a Y-axis motor. Any help would be much appreciated, thank you.
Electronics Forum | Thu Aug 06 19:37:45 EDT 2009 | voytek
I am looking for replacement pump motor for CAMALOT 1818 or company which is able to repair it. Motor manufacturer is MICRO MO P/N 3042W024CR. Thank you,
Electronics Forum | Wed Oct 20 03:56:19 EDT 2010 | michaellaw
Hi, Some idea for you to troubleshoot: *It could be the motor problem,check all motor power,after ON power to m/c,the motor should be engaged. *stepping driver spoil
Electronics Forum | Wed Jan 19 15:41:10 EST 2011 | jmw
take apart the bad motors....save the good parts.....then order new motors that work......problem solved
Electronics Forum | Sat Oct 29 14:33:34 EDT 2011 | tech1
Try swapping out the motor controller boards and see if the problem moves. More than likely it is the motor, coupling or the encoder. Some of the suggestions about reducing the acceleration in the package is a good idea but this will not provide a lo
Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Thu Jul 25 14:44:34 EDT 2013 | falvarez
Im needing an Rising table motor for Dek Horizon, but with a 4000 count encoder, because that motor i bought become with a 1000 count encoder and not worked. any suggestion?