Electronics Forum | Wed Feb 22 21:27:04 EST 2006 | gcolbert
Our solder paste machine has a squeegee problem. After passing over a board, the squeegees don't go all the way back up to their origin state. Then we are getting a timeout error and have to return the machine back to its origin (manually), and pass
Electronics Forum | Wed Jul 03 15:44:30 EDT 2002 | mantis
If the designer has used pin one as origin surely all parts on the board would have pin one as orign and all parts would be off be same amonunt.If u like you can send a copy of your PD and i would be happy to review it for you and see if theres anyth
Electronics Forum | Wed Feb 14 15:24:24 EST 2018 | cbart
I assume you verified the pin support table was not actually stuck or still in the up position?
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Tue Sep 01 17:16:46 EDT 2009 | andoe
had tried all of that / went into proper data and changed the origin to the corner instead of the pin, it started working. thanks for the responce - ron
Electronics Forum | Tue May 22 15:20:57 EDT 2012 | cbeneat
Reese, no stayed perpendicular in regards to the wave, however on the 90deg clockwise turn from original(connector trailing)we had some bridging on the pins on the right in my first picture.
Electronics Forum | Thu Jul 09 13:19:38 EDT 2009 | emanuel
Just in case somebody will bump in the same situation and looks for a possible solution, the problem was with a small 2 pin connector that feeds one of the W DC motors. The connector looked ok, but one of the pins pulled a little out and was making
Electronics Forum | Thu Oct 21 06:26:50 EDT 2004 | dennispoquiz
Right. Fiducial comes with the CAD data or the gerber files. If it doesnt, and you need to create fiducial coordinates, you may use a digitizer or a caliper and make use of the reference pin as the origin. Now if the fiducial camera focus is way out,
Electronics Forum | Mon Nov 05 01:31:58 EST 2007 | jmelson
Well, that was a bit of a lucky guess. There are a number of things that can cause that message, and the programmer of the system DID have enough information to make the error message a LOT more specific if he'd wanted to. When machines cost what t
Electronics Forum | Sun Nov 04 19:13:25 EST 2018 | cirsol
Thanks. Have tried registering again and sent ASM an email. Since my original post I have been able to locate the user manual with schematics etc, but the documentation that I have is still quite lacking in terms of troubleshooting and defining machi