Electronics Forum | Fri Apr 12 15:48:33 EDT 2002 | jersbo
SPC for each assembly(I use C(for board defects)NP(for unit defects) at the end of reflow to determine process capabilities determine Control limits. Once control limits are set, inspectors stop the process until out of control limit is addressed and
Electronics Forum | Mon Dec 09 14:31:21 EST 2002 | swagner
You want to use a rubber squeegee with as high as a durometer as you can get away with, order two or three sets of blades starting with the softest and then progress up the the hardest, the reasoning behind this is the softer squeegees will wear out
Electronics Forum | Fri Aug 18 23:42:33 EDT 2006 | Efren
Hi Guys, As always, you bring interesting advices. I just take an idea about the issue. I will let all of you know about my progress, and I expect to share my experiences too in this forum as a matter of retribution for the advices I already have re
Electronics Forum | Wed Oct 24 16:54:54 EDT 2007 | dekhead
It's an Horizon (01) with large board (24" x 30")capability. Some software issues, as the OEM stopped progressing software on this machine (an offshoot of Horizon 7SP02) and never made final release Typhoon software compatible with this (Same with Vi
Electronics Forum | Mon Jul 15 13:44:52 EDT 2013 | rollon65
Hi Chris. Thanks for the reply. There has been no progress since my post. I was trying to see if I could repair the MVS PCB with IC swaps as it looks a bit cooked in places but if I could find a reasonably priced one I would be interested. I also
Electronics Forum | Tue Jul 17 22:15:32 EDT 2018 | pcbindex
Hey, Matt, I am also a newcomer to PCB design. This is a PCB website I know (http://www.pcbindex.com/). You can also go in and find out. I hope you have any good suggestions. Share with me, I can make progress together. Thank you
Electronics Forum | Thu Nov 15 11:03:17 EST 2018 | bobpan
When our older Ekra machines wont reference.....we will either try to e-stop it and then turn the control back on and reference it again....or turn the machine off and back on. I would check all the sensors on the machine and also try to reposition
Electronics Forum | Wed Nov 13 09:26:10 EST 2019 | bobpan
I think it has something to do with the communication between the 2 computers. Plug a monitor into the back computer rack and see if there is an error showing when its trying to boot up. Its been a long time....so dont quote me....ha
Electronics Forum | Fri Jun 26 14:20:54 EDT 2020 | victorzubashev
Great news that you have progress Lazslo! I was sure that the problem you described - is a hardware issue and not Software (MC, SR ...). regarding" pinole of" do you mean sleeves? Please send me an email, so I can help you. victor.zubashev@qbotech.
Electronics Forum | Thu Aug 12 18:35:02 EDT 2021 | oxygensmd
Press emergency button, release it and you will get an error report. Sometimes table motor doesn't work properly on my EKRA E5 and I see where to search if something not okay. Let me know your results.